Why won’t this app discover my brand new C328 amp?
Why won’t this app discover my brand new C328 amp?
Constantly crashes
App constantly creases. Previously, it worked reasonably well. Would be great to get it back to being stable. Makes use of the my NAD M17 much easier and more enjoyable.
Stopped working
App seems to have stopped working on all devices.
No longer works
The app stopped working completely last week. No longer shows anything other than a blank screen
Zone 2 Volume Adjustment Greyed Out
App connects quickly to T 758 and works well with the settings allowed to adjust.
Unfortunately when attempting to adjust the volume on Zone 2 even when the amplifier has been set to variable for volume on Zone 2, it will not allow the volume to be adjusted and is greyed out. Zone 2 for my set up is located outside in the patio so running in and out of the house to adjust Zone 2 volume with the Z7 remote is a bit of a pain.
Unfortunately when attempting to adjust the volume on Zone 2 even when the amplifier has been set to variable for volume on Zone 2, it will not allow the volume to be adjusted and is greyed out. Zone 2 for my set up is located outside in the patio so running in and out of the house to adjust Zone 2 volume with the Z7 remote is a bit of a pain.
Show less
Freezes up
I've been using this for about a year on an iPhone 6. Since the ios 11 this app freezes constantly. It seems when the phone goes to standby it disconnects with the receiver.
A minor bug fix I suspect but very annoying.
A minor bug fix I suspect but very annoying.
Ok
Seems to work well. However, it Does not support basic video/audio output info for the vm300.
iOS app is great. Where is the Android version??
I absolute love this app for controlling my family room setup. It would be a crime if you didn't port this to Android. Like most houses we have a mix. I'd be able to put the remote in a drawer forever and that would be fine by me. How hard can it be?
Settings
Had to contact NAD support to get this working, but now that is does it’s fantastic. I have control from anywhere I can connect to my home network. The key was setting the baud rate high enough on my GlobalCache IP2SL device (needed for the RS-232 non networked models). The app wouldn’t find my T758 receiver until the rate was set to 115,200. So for anyone else having a “device discovery” issue from the app and are using a serial port to network type device, try these settings:
Baud: 115,200
Flow: None
Stop Bits: 1
Parity: None
Data Bits: 8
Baud: 115,200
Flow: None
Stop Bits: 1
Parity: None
Data Bits: 8
Show less
App doesn't discover T787 on standby...
Always have to power cycle using rear switch. What's the point?