LaserCalc Mobile

Version 2.0.2 Fixes an occasional freeze when navigating through the load calc wizard Version 2.0 adds LaserCalc Pro. PRO: SCAN A ROOM WITH LiDAR Walk the room and let the phone measure it. LiDAR picks up the walls, the ceiling height, and the windows while you move, so a room is done in seconds. No tape measure, no notepad, no typing it in afterward. LiDAR scanning needs an iPhone Pro or an iPad Pro. PRO: SCAN A ROOM WITH YOUR CAMERA No LiDAR on your phone? Use the camera instead. Aim at each corner of the room and tap. You get the same room-by-room numbers on any device that runs LaserCalc, and it is a genuine alternative, not a consolation prize. PRO: ROOM-BY-ROOM REPORTS A heating and cooling load for every room, not one number for the whole house. That is what sizes the equipment and balances the ducts, and it goes straight into the PDF you hand your customer. NEW FOR EVERYONE More than 2,700 ASHRAE cities. Odds are the town you are standing in is on the list now, with its own design temperatures instead of the nearest big city's. LaserCalc speaks Spanish. The app follows your device language, and you can switch it any time in Settings. New questions in the load calc: number of floors, ventilation and combustion air, duct system layout, and fireplaces. Each one feeds a Manual J load the calc could not see before. The address lookup fills in more for you. Along with square footage it now pulls stories, fireplaces, floor type, and occupancy from the property record when they are on file. Every one of them stays yours to change. Closer to Manual J. Two-story infiltration, per-fireplace infiltration, graduated duct factors, and the MJ8AE appliance allowances are all figured the way the spec asks for them. Numerous design improvements and fixes.