MotionMIDI

Pad buttons can now follow your host. Set a button to Host Feedback and it lights from incoming MIDI rather than its own press — so a looper clip stays lit while it plays and goes dark when it stops, however it stopped. Started from the host's own screen, ended by a scene change, or run to the end: the button tells the truth either way. CC MAP - Edit a button's message type, press behavior, and lit source directly from its row - Add a button without leaving the map - Collapse any section; collapsed sections still report their conflicts - Shift every channel in a section up or down together - Note buttons now appear alongside CC buttons - With two performer surfaces, a Left / Right selector — and conflict detection that spans both, since they share one port STEPPED DIAL - Steps can now reshape the pad itself: switch between Standard XY, 4-Corner Morph, Drawbars and Notes, retarget either axis, retarget a single morph corner, or set the release behavior - Save a dial as a new library entry, or save over an existing one — with a warning telling you how many presets it affects - Pair a dial on the left surface with any dial on the right. Turn either and both move to the same step. Names don't need to match, and each dial keeps its own steps XY PAD - Morph mode has its own release targets: hold, even blend, any single corner, or any edge centre FIXED - Editing the master scale, root or range now takes effect immediately instead of sitting behind a dial step that was holding a different value - Turning a dial no longer re-applies a scale from a different dial that hasn't been touched. The dial you last turned describes the pad; anything its step doesn't mention falls back to your master values