# SolarLife BT — user reviews > 11 indexed App Store user reviews of SolarLife BT by 江西达伙网络科技有限公司, rated 2.71/5 from 14 ratings. - Source: https://appshunter.io/ios/app/solarlife-bt/id1522399442/reviews - App overview in markdown: https://appshunter.io/ios/app/solarlife-bt/id1522399442.md - Rating breakdown: 5★ 2 · 4★ 1 · 3★ 5 · 2★ 3 · 1★ 3 ## Most critical reviews (10 lowest-rated) ### 1/5 — Won’t register any data *2023-10-13, version 1.3.1* I can successfully connect via Bluetooth (even though you have NO IDEA what the Bluetooth name is). After 30 minutes of waiting the app still won’t show any data for the battery or MPPT controller. I have tried many times. I can’t seem to be able to contact the developer either. ### 2/5 — No load and disconnects constantly *2024-10-12, version 1.3.4* 4 years and LOAD still doesn’t work. ### 2/5 — Disconnects often *2024-09-26, version 1.3.4* The app doesn’t stay connected to the charge controller. It’s exactly what I need when it works, but it’s frustrating to have to manually reconnect it 7-8 times in a row. ### 2/5 — Bluetooth issues and no Load *2023-07-23, version 1.3.1* Read the order reviews. Same thing for me. Please fix these two issues and it’ll be a great app. ### 3/5 — BT Memory *2025-06-17, version 1.3.5* It’s a decent app. Not much available in the way of instructions, making it a little challenging if you’re new to solar, but it’s straight forward enough and easy to figure out. My one improvement request is that the app would retain the BT unit selection when you open it. It’s cumbersome to have to scroll through every BT device with a radio to locate the unit and connect to it. Seems like this should be a simple fix that would shore things up a lot! ### 3/5 — Not showing load *2025-03-11, version 1.3.5* Everything works except load ### 3/5 — Increase LVD limit to 12.4 *2024-01-12, version 1.3.2* Had trouble starting the car the other week because the accessory cut off was set to the recommended 11.2v which was too low for my rav4 4 cylinder. ### 3/5 — No load *2023-01-19, version 1.3* As the other reviewers stated the Bluetooth doesn’t stay connected (small inconvenience). The larger issue is it isn’t monitoring the load on the battery bank. If this was fixed in a update I would give it four stars. ### 3/5 — Decent, but needs a bit of work *2022-04-02, version 1.2.8* Decent app. 3 stars because it constantly disconnects. I can reconnect it easily but it’s still annoying. If the app would at least attempt to reconnect automatically, I’d give it 5 stars. A few seconds of not showing values while reconnecting is better than having it fully disconnect and require me to reconnect manually. ### 4/5 — Works *2023-03-03, version 1.3* Generally works and reports what it gets from the controller. I wish it would remember what I connected to last and automatically reconnect and show the status page instead of the connect page. There are a couple of things but it might be the fault of the controller. The app reports an inaccurate battery percentage and charge status. Says 99% but battery is at 13.4V. Also reports always in chargefloat mode even if I change the thresholds. I see current going into the battery so I’m probably good for my application (automotive AGM top off charger). ## Most praised reviews (1 highest-rated) ### 5/5 — For now the 5 stands *2022-08-29, version 1.3* The LOAD screen parameters remain at zero even when a 6A load (light bar) is on and running….the app has run flawlessly on PV and BATT…easy setup etc…except for load side --- *Data collected daily from the US App Store and indexed by [AppsHunter](https://appshunter.io/). User reviews are verbatim App Store reviews. Ratings, prices and chart positions refresh continuously; this snapshot is from 2026-08-03.*