BendRight

Measure first: every screen asks for the field measurement at the top, then gives the marks, then shows the bends. New in 1.2: - Marks account for the bend's arc, not just the multiplier, and the chart number shows right next to it so you can see the difference. - Lay out an offset from where it lands: tell it where the pipe has to be flat, get both marks, and see both bends drawn to your shoe, roll and all. - Scan the run (iPhone): aim where the pipe starts to rise and where it has to land, and the offset is drawn there as conduit, with the rise and angle sent to the Offset screen. - Field tools under More: voltage drop on a run, ground wire sizes by breaker and by service, and which phase and color a panel space lands on. - A bending handbook under More: multipliers and shrink, deducts and gain, the marks on your bender, how each bend goes, field tips and fractions, with search. - Pull the Pin: the job lines IBEW inside locals post on their own sites, plus the IBEW Jobs Board. - Segment and concentric screens redone in the new layout, under More. - Your bender: pick yours from the library, then calibrate the take-up to your own shoe. - Job profile: send your take-up and radius to the crew as a code, QR or link, or open the foreman's code so the whole crew bends to the same numbers.