Crown Cut: Miter & Bevel

Crown Cut: Miter & Bevel

Crown molding, cut flat

2 ratings
Free

Rating summary

Details

Released
November 6, 2026
Updated
November 7, 2026
Crown Cut: Miter & Bevel screenshot #1 for iPhone
Crown Cut: Miter & Bevel screenshot #2 for iPhone
Crown Cut: Miter & Bevel screenshot #3 for iPhone
Crown Cut: Miter & Bevel screenshot #4 for iPhone
Crown Cut: Miter & Bevel screenshot #5 for iPhone
Crown Cut: Miter & Bevel screenshot #6 for iPhone
🖼️Get Icon
Icons↘︎

About

Get a clear setup for cutting crown molding flat on a compound miter saw. Enter the angle between your walls and choose a 38° or 45° spring angle, or enter the measured angle of your own molding. Crown Cut calculates the miter and bevel settings and shows the directions from the operator's position. SEE EACH STEP • Top and front saw views show how to turn the table and tilt the blade. • Choose inside or outside corners and the left or right piece. • See which molding edge goes against the fence and which side to keep. • For a left-bevel-only saw, see when to rotate the molding 180° on the table while keeping it face up. MEASURE FROM THE RIGHT POINT • Select whether the other end is square, inside or outside. • See the existing cut, the new cut, and the wall-contact edge used for length L. • Follow long-point and short-point instructions for every end combination. SAVE YOUR SAW AND ROOM • Add named saw profiles with separate left and right miter and bevel limits. • Receive a notice when a calculated angle exceeds your saved limits. • Use a rectangular or L-shaped room plan, record individual corner angles, mark pieces done, and share a cut list. • Use the large at-the-saw view with the screen kept awake while it is open. Works offline. No account, advertising, subscription or in-app purchase. Room measurements and saw profiles are stored on your device. English and Russian interfaces, with automatic iPhone language selection or an in-app choice. The calculation assumes matching molding on both walls, equal spring angles, plumb walls and a level ceiling. Room plans and saw drawings are schematic. The app checks angle limits; cutting width and height depend on your saw. Verify your setup with the saw manual and make a test joint with two scraps first. Crown Cut is an independent app and is not affiliated with or endorsed by any saw manufacturer.
Show more

What's New in Crown Cut

1.5

November 7, 2026