CutOnce - Builder's Calculator

• New stair baluster layouts. Choose Limit Opening, Fixed End Space, On Center, or Best Fit, pick where your marks are measured from, and CutOnce gives you the running mark for every baluster on the card, on the tape, and in the stair PDF. • New Spacing calculator. Lay out pickets, shelf pins, holes, or anything else evenly along a run, and read cumulative tape marks from the leading edge, center, or trailing edge, with true horizontal clear space on sloped runs. Deck railings can now share one common on center across sections. • Safer stairwell openings and a fuller code check. The minimum stairwell opening now allows for the full tread run and the upper finished floor, and the stair report now checks guard openings, nosing, the 6 inch triangle, and headroom. • New Box and Frame Miter calculator. Building a box, planter, or sloped frame with any number of sides? Enter the sides and the tilt and CutOnce works out the saw table miter and blade tilt for every cut, and warns you when a tilt is past what your saw can do. • Clearer, more accurate hip and valley PDFs. We tightened the jack schedule, plate and datum marks, note rounding, and rafter length wording, and rebuilt the optimized cut map into a clean Qty, Size, Length, and Pieces table. • Birdsmouth warnings on your cut plans. Rafter and hip and valley cut plans now print a graded warning when a birdsmouth cut runs too deep for the rafter, so you catch it before the cut. • Better wall stud lumber lists. The wall stud PDF now calls out the pressure treated bottom plate as its own item instead of pairing it with untreated stock, so the purchase list is one you can actually buy and build. • More in Spanish. Masonry mortar product names and more PDF labels and notes are now available in Spanish. • Smoother purchases and setup. We made restoring a purchase more reliable and streamlined the trial and first run experience.