
EngiTools Pro: MEP Calculator
HVAC, Water Pump, Pipe & Cable
0 ratings
Free
In-App Purchases
Rating summary
About
15 MEP engineering tools in one app – pumps and piping, HVAC, electrical, fasteners and unit conversion. Fast, accurate and offline.
Work out pump head, size pipes and ducts, read the psychrometric chart, size cables, look up flange and bolt dimensions and convert units in seconds – on site, in the plant room or at your desk. Built for MEP / building services, plumbing, HVAC and mechanical engineers, technicians and students.
PUMPS & PIPING
• Pump Head – total head step by step: pipe friction, fittings, suction and discharge.
• Pipe Sizing – the smallest pipe size within your velocity and pressure-drop limits.
• Pipe Thickness – OD, ID, wall thickness and weight by DN/NPS and schedule.
• Pipe Support Load – load on each support from pipe, water and insulation weight.
• Flange Size – BS 1092-1 weld-neck flanges: PCD, bolt holes, neck dimensions and bolting.
HVAC & AIR
• Psychrometric Chart – enter any two of dry bulb, wet bulb and RH to get dew point, enthalpy, humidity ratio, absolute humidity and density. Mix two air streams.
• Duct Sizing – round and rectangular ducts from airflow with velocity or friction rate; equivalent diameter and aspect ratio. SI and IP units.
• Fresh Air – outdoor air rates by room type.
• Fan Power – air power, shaft power and motor input.
• Air Changes (ACH) – air changes per hour from airflow and room size, or the other way round.
• Heat Transfer – sensible heat from flow rate and temperature difference; leave any one value blank to solve for it.
ELECTRICAL
• Cable Sizing – current-carrying capacity and voltage drop to the Hong Kong wiring code (CoP).
FASTENERS
• Bolt / Nut / Washer – hex bolts, screws, nuts and flat washers to ISO, DIN and BS: pitch, width across flats and corners, head height and thread length.
DATA & UNITS
• Unit Converter – 12 categories including pressure, flow, energy, power and temperature, with scientific notation.
• Fluid Properties – water, air, 50% ethylene / propylene glycol, refrigerants (R-134a, R-410A, R-717), CO₂, N₂ and O₂: density, viscosity, specific heat and more.
WORK FASTER
• Search every tool, unit and fluid; browse tools by category; pick up your last calculation in one tap.
• Save calculations, organise them into projects and find them again with search.
• Light and dark mode; layouts for iPhone and iPad.
• All tools work offline – no signal needed in plant rooms or basements.
• Data from recognised standards – ASHRAE, BS, ISO and DIN.
(Note: EngiTools Pro is intended for general reference. Users should always verify calculations with official standards for critical engineering designs.)
Show more
What's New in EngiTools Pro
1.0.9
November 5, 2026
• Bug fixes and performance improvements. Thanks for supporting EngiTools Pro!
1
Subscriptions & In-App Purchases
$4.99
Upgrade to Premium
Purchase to remove Advertisements









