FieldCalc: HVAC & Plumbing

FieldCalc is the calculator set for people who actually install and service the equipment. It is built around the numbers you reach for on a call — duct sizes, charge, load, pipe volume, grade — and it runs entirely on the phone. No signal in the crawlspace. No account. No data leaving the device. AIR SIDE --------- • Ductulator — round and rectangular sizing, with velocity and friction rate updating as you type, plus the next standard size up • Ventilation & ACH — air changes, outdoor air rates and exhaust requirements • Airflow by temperature rise — CFM from furnace rise, the fast field check REFRIGERATION ---------------- • PT chart — 16 refrigerants with bubble, dew and glide, from CoolProp's Helmholtz equations of state rather than a typed-in table • Superheat — target superheat for fixed orifice and TXV systems, with live off-target and an explanation of what it means • Subcooling — liquid side charging against nameplate LOADS & EQUIPMENT ---------------------- • Block load — whole-house heating and cooling estimate with a full breakdown of where the load comes from, so you can see what is driving the number PLUMBING ----------- • Pipe volume — fill, weight and chlorination dosing • Offset & rolling offset — travel, run and cut length for any angle • Slope & grade — fall, percent grade and code minimums UTILITIES ---------- • Unit converter — every unit the trade actually uses • Reference library — copper, steel and PVC dimensions, duct tables and refrigerant properties, bundled in the app WHY IT IS DIFFERENT --------------------- Refrigerant properties are computed from real equations of state, not interpolated from a screenshot of a chart. Glide is shown for every blend, so you know when bubble and dew actually differ. Every result shows its working. Tap the sigma to see the method, the inputs and the assumptions behind a number, because a calculator you cannot check is a calculator you cannot defend to an inspector. Warnings are advisory, not blocking. If the velocity is high, FieldCalc says so and tells you the target it is comparing against — then gets out of the way. Both unit systems, everywhere. Switch IP and SI per screen without losing your inputs. HONEST ABOUT SCOPE ------------------------ The block load is a block estimate. It is a solid sizing sanity check and it shows you its assumptions, but it is not a substitute for a room-by-room Manual J when the job calls for one. FieldCalc tells you that on the screen rather than hiding it in a disclaimer. Built for HVAC technicians, refrigeration techs, plumbers, sheet metal workers, service managers, estimators and apprentices. Privacy Policy: https://www.mindzbase.com/privacy-policy Terms of Use: https://www.mindzbase.com/terms-of-use InApp and Subscription Info --------------------------- Lifetime inApp purchase | $9.99