
FuelTech Vision
VisionFT
About
What's New in FuelTech Vision
00.03.12.00
November 18, 2026
Version 00.03.12.00 CAN ACCESSORIES • VisionFT Expander (dash, inputs and outputs): a PowerFT FT450, FT550 or FT600 connected to the CAN network now works alongside the VCU as a display and as an input and output expansion. The function is in "My VCU" > "VisionFT Expander (dash, inputs and outputs)", where you choose the "CAN port" (CAN A, CAN B or CAN C) and the "Power model". – Display: the PowerFT shows the VCU readings, such as RPM, TPS, MAP, oil, fuel and water pressures, lambda, ignition timing, injection time and duty of banks A and B, engine, air, oil and transmission temperatures, four-wheel speed and battery voltage. – Outputs: the PowerFT pins appear in the Blue, Gray and Yellow groups of the output selector of any function, with "(CAN)" in the name, for example "Blue 3 (CAN)". They switch on/off or work in PWM, using the frequency and inversion of the function itself. There are 32 pins on the FT600, 24 on the FT550 and 10 on the FT450. – Injection, ignition, electronic throttle, stepper motor and analog outputs remain on the VCU's own outputs. – The "Power CAN outputs in use" panel shows which function uses each PowerFT pin, and Diagnostic shows the state of each output. – Inputs and buttons: the PowerFT presents itself on the CAN network as an Input Expander, and the VCU reads its inputs and the PowerFT display buttons like those of an Input Expander. GOOD TO KNOW AFTER UPDATING • Update the VCU together with FuelTech Vision. The VisionFT Expander requires the new VCU firmware. • PowerFT firmware: to use the PowerFT as a VisionFT Expander, install the VisionFT Expander firmware on it through FTManager. Changing the firmware erases the PowerFT map and dashboards.
More



