Kickmark: Conduit Bending

Kickmark tells you exactly where to mark your conduit and which way to bend it. Pick a bend, type the numbers from the job, and Kickmark gives you every mark measured from the end of the pipe, rounded to the nearest 1/16". An animated diagram then walks you through each bend in order: which mark lines up with the arrow, when to use the star, when to roll the pipe 180°. FREE, FOREVER • Offsets at 10°, 22½°, 30°, 45° and 60°, with shrink • 90° stubs using the take-up of your bender • Bender library: EMT, IMC, rigid and PVC, ½" to 2" • History of your last 100 bends • English and Spanish, inches or millimeters KICKMARK PRO (ONE PURCHASE) • 3-point saddles (45° or 60° center) • 4-point saddles • Rolling offsets, with true offset and roll angle • Back-to-back 90s • 90s with a kick • Custom bender profiles TRADE OR EXACT: YOUR CALL Trade multipliers (6, 2.6, 2, 1.4, 1.2) and exact trigonometry can disagree by 1/8" or more. Kickmark shows both, clearly labeled, so you always know which number you are looking at. YOUR BENDER, YOUR NUMBERS Take-up varies from bender to bender. Start with the common values, or type in the number stamped on your own bender. Rigid, IMC and larger sizes ask you to confirm the number first. PAY ONCE No subscription. No trial that bills you later. No ads. No account. No data collected. Works offline in basements and on sites with no signal. Restore your purchase on any device signed in with the same Apple ID. Kickmark is a layout aid. Check every bend, and follow the electrical code and your job specifications.