NexPool Connect

A completely new look The whole app has been redesigned around a clean, light interface — dashboard, pump, heater, salt cell, lights, settings and everything in between. Set up your pool by body of water Pool and spa are now separate cards, each with its own slots for a pump, heater, sanitiser and flow meter. Tap a slot to add or edit that piece of equipment, including its valves, all in one place. Add features like a blower, fountain, waterfall or fireplace and assign each one a relay channel. The app warns you about problems before they matter — equipment shared between two bodies with no valves to switch it, freeze protection with no flow meter to read, or two features wired to the same channel. New Usage tab See what your pad actually did: pump energy over the last 7 or 30 days, hours run, gallons filtered, and how many times that turned over your whole pool. Days where your controller was offline are marked, so a short bar is never mistaken for a quiet day. Notifications, rewritten Alerts are now grouped by day and colour-coded by how urgent they are, and each one shows which piece of equipment raised it. Tap to mark one as read, or mark everything at once. Weather and swim days Tap the weather in the header for a multi-day forecast. Days good enough to swim are badged, and when one isn't, the app tells you exactly why — too cold, too wet or too windy. Change equipment without starting over Settings now has an Equipment section for adding or replacing devices after setup. Replacing a pump keeps your schedules and settings pointing at the new one. Fixes Push notifications now arrive reliably. Alerts sent to this version of the app were not reaching devices; they are now. A gas heater's fireman switch can only be assigned to the two relay channels built for it, so it can never be wired to a valve by mistake. A partly configured device no longer hides your whole pool. Valve assignments on a pump are saved correctly and are there when you reopen the device. Creating an account now completes properly and registers your controller. Dropdown menus near the bottom of the screen open upward instead of off-screen. The press-and-hold ring on the pump and heater is visible again. Smaller download.