PipeFitAR: Pipefitter Layout

PipeFitAR: Pipefitter Layout

AR Cut List & Fitting Takeout

0 ratings
Free

Rating summary

Details

Released
November 13, 2026
Updated
November 15, 2026

Features

PipeFitAR: Pipefitter Layout screenshot #1 for iPhone
PipeFitAR: Pipefitter Layout screenshot #2 for iPhone
PipeFitAR: Pipefitter Layout screenshot #3 for iPhone
🖼️Get Icon
Icons↘︎

About

Aim, tap, and PipeFitAR turns a pipe run into a cut list — take-outs and weld gaps already subtracted. Point the crosshair at the wall, ceiling or rack where the pipe goes and drop a point at each centerline change. PipeFitAR builds the run in AR, works out center-to-center for every leg, and gives you cut lengths for the fittings you picked. CUT LIST, NOT JUST A TAPE • Cut = center-to-center − fitting take-out − weld gap, per leg • ASME butt-weld elbows 1/2"–12" NPS: 45 LR, 90 LR or SR, and 90s cut to any angle • Tees, reducers, weld-neck and slip-on flanges (150# and 300#), gaskets and bolt sets • Socket-weld and threaded take-outs, couplings on straight runs (up to 2") • Pipe can sit tight to the surface, at a set standoff, or on an existing pipe's centerline HONEST ACCURACY • Run 3 or more tape tests and PipeFitAR learns how far off your phone reads • Every cut shows its ± so you know which ones to tape before cutting • Tap any cut to type the real tape C-C; a tape pass walks you through the untaped ones • Snap to level, plumb and 45° with a haptic tick when it locks ON THE JOB • Walk-out: run / roll / rise from the last mark, with check-offs • Iso sketch with C-C dims and fittings — share it as a picture • Material list: pick 20', 21', 24' or 40' joints, enter drops on hand and they get used first • Save jobs by name. With the room scan saved, the run snaps back into place when you come back • Flashlight button for dark mechanical rooms; screen stays awake PRIVATE BY DESIGN No account, no ads, no tracking. Everything stays on your iPhone. AR gets the shape; your tape gets the numbers. Measurements are estimates — verify every cut with a tape before cutting or welding. Works best on iPhone Pro models with LiDAR. Questions or a fitting you need added: support@unitus.dev
Show more
+2

What's New in PipeFitAR

1.0.1

November 15, 2026

Use your own take-offs: in the cut list, open Fitting take-offs and type the 90, 45 and tee numbers from your supplier's catalog for each size and joint type. Leave one blank to keep the standard number. After each update, a short card now shows what changed.

More