
PipeFitter Calculator: Offsets
Pipe Fitting Cut Lengths
0 ratings
Free
About
PipeFitter gives you the cut length for the piece between two fittings. Pick the layout, type what you measured, read the cut.
FIT
• Offset, rolling offset, offset to tee, jumper and parallel offsets
• 90°, 60°, 45°, 30°, 22½° and 11¼° elbows
• A fabrication drawing for every layout, with lettered callouts tied to each value
• Take-outs and weld gap worked into the cut length, with the working shown
• Set the pipe once: material, type, size and elbow
PIPE AND FITTINGS
• Butt-weld steel and stainless, long and short radius
• Copper, threaded, grooved and socket-weld steel, PVC, CPVC, ABS and PEX
• Enter your own fitting take-outs for anything else
• Pipe and elbow tables for reference
CALCULATOR
• A trade calculator with Offset, Run, Travel, Angle, Roll and Take-out keys
• Feet, inches and fractions, or millimeters
• Flow, velocity and pressure
• Pipe weight and water volume for the pipe you picked
• A built-in guide that walks through common problems key by key
No account, no subscription.
The Offset layout is free. Everything else can be tried with a free trial and unlocked with a one-time purchase.
Always check results against your drawings and the applicable codes before cutting.
Show more
What's New in PipeFitter Calculator
1.0
November 13, 2026




