Raceway: Conduit Bending

Raceway turns conduit bending into marks you can put on the pipe — corrected for the bender in your hands. Pick your bender and Raceway uses the take-up and centerline radius its manufacturer publishes for that exact model. Popular Greenlee and Klein EMT hand benders are built in. For any other bender, read the take-up off the shoe and add the radius from one quick test bend. Every number shows where it came from. MARKS YOU CAN BEND TO • Every mark measured from the end of the conduit • Which bender mark to line it up with — arrow, center mark or star • Which way the bend forms and when to roll the pipe 180° • Corrected for bend radius, with the difference from the multiplier chart shown • Bends your bender physically can't make are caught, with angles that will work BEND TYPES • Offsets, including parallel runs • Rolling offsets • 3-point and 4-point saddles • 90° stubs and back-to-back 90s BEND MODE One mark at a time with huge numbers, glove-sized buttons and the screen kept awake. Bends are confirmed in order, so an accidental tap can't skip one. ANGLE FINDER • Live meter using your iPhone's motion sensors: zero on one leg, read the other, hold the reading • Estimate a bend from a photo by placing two lines on the legs (you place the lines; there's no automatic detection) • Opens from Bend mode with the target angle ALSO • Voltage drop with minimum wire size and maximum length • Tape-measure fractions to 1/16" • Every result shows its math and assumptions, and saved results keep the bender values they used • Fully offline. No account, no ads, no subscription, no in-app purchases — nothing leaves your phone. IMPORTANT Raceway is a calculation aid for trained electrical workers. Its bending marks and angle readings have not been field-validated: bend and measure a test piece before you bend a run, and confirm angles with an angle finder. Results are not a code-compliance decision — follow your code book and your authority having jurisdiction. Raceway includes no electrical-code tables. Manufacturer names are used only to identify compatible benders; Raceway is not affiliated with or endorsed by any manufacturer.