SmarTruckHD

SmarTruckHD is the companion app for SmarTruckHD radar sensors. Connect over Bluetooth to set up, fine-tune, and maintain your radar directly from your phone — no laptop or special cables required. KEY FEATURES • Scan & Connect — Find nearby SmarTruckHD radar sensors over Bluetooth Low Energy and connect in seconds. • Detection Zones — Configure the ignore area, warning area, and left/right detection width to match your vehicle. • Alarm Zones — Set the red, orange, yellow, and yellow-green distance zones for graded proximity alerts. • System Parameters — Adjust speaker volume, radar sensitivity, install height, trigger distance, trigger delay and interval, alarm-off delay, and working speed range. • Speed Limits — Define the minimum and maximum speed window in which the radar stays active. • Radar Self-Learning — Start the built-in learning routine to calibrate the sensor to its installed surroundings. • Factory Defaults — Restore the recommended configuration with one tap. • Device Info — Check the sensor's software and hardware version at a glance. • Metric & Imperial — Work in meters and km/h, or feet and mph. • Multilingual — Available in English, Chinese (Simplified), Spanish, and Italian. BUILT FOR INSTALLERS AND FLEETS Visual top-view and side-view diagrams show exactly which distance you are editing, so installers can configure a vehicle correctly on the first visit. All settings are read from and written to the sensor itself — nothing to sync, nothing to lose. NOTE This app requires SmarTruckHD radar hardware. It is a configuration tool and does not display live radar alerts. Bluetooth must be enabled on your phone.