Engine Horsepower Calculator vs Pipefitter_Pro

Engine Horsepower Calculator are used to estimate the engine horsepower of your vehicle based on the weight, the time, and the speed to finish a quarter mile run. The weight to be used should include the mass of the vehicle, the driver, the passenger, and other load. The results of these calculator are estimations only. Horsepower Calculation Method The ET Method This method uses the vehicle weight and the elapsed time (ET) to finish a quarter mile (402.3 meters). The Trap-speed Method This method uses the vehicle weight and the speed at which the vehicle finished a quarter mile (402.3 meters) . The speed to be used here should be the finishing speed at the quarter mile point. The RPM Torque Method This method uses the torque value from the vehicle manual book, The RPM should indicate the maximum torque output. Thanks for your support and do visit nitrio.com for more apps for your iOS devices.

Pipefitter Pro is a calculator for pipefitters. It calculates offsets, elbow angles and spool lengths, and draws what it works out. Choose a case from the menu, enter the pipe diameter and elbow radius on the workshop keypad, then read the available results: angles, the spool between elbows, elbow takeout, arc lengths and caliper dimensions. CASES AND VIEWS • BACK TO BACK — two elbows, with either the angle or the offset unknown. • S TYPE — offset, travel or a fixed 45° option. • TEE OFFSET — calculations that include the branch diameter. • CALCULATOR — one elbow cut out of a 90°. • 3D — two elbows in space, set using the A, B and C dimensions of a box. • SLIDER / SLIDER S TYPE / SLIDER TEE — change the angle and watch the offset change. • 3D SLIDER — set the elbow orientation in a spatial model and read the angles, the insert and the live box dimensions. The box is a visual reference, not a cut length. Depending on the case, results appear on the Angle, Dimensions and Elbow tabs; selected cases add a 3D view you can rotate and zoom. UNITS AND INPUT Lengths in millimeters, centimeters and inches. Feet-and-inches notation and decimal or fractional inches are also supported. Choose 1/16 or 1/32 precision for inch fractions. Angles are given in decimal degrees. The workshop keypad and fraction picker help you enter dimensions; add frequently used cases to favorites. PIPE AND ELBOW DIMENSIONS The DIMENSIONS tile opens the built-in NPS/DN table. It contains outside diameters and centerline radii for long-radius and short-radius elbows. Add and edit dimensions, then use them in calculations. Save a list backup to a file and restore the list from a backup. BEFORE YOU CUT Pipefitter Pro supports the preparation of workshop work. Check the dimensions against your technical documentation and your shop procedures before cutting and welding.