IPSC BlackOut vs Power Factor Estimator

BlackOut is a scoring application. It loads IPSC match data from MakeReady match management system and allows to enter scoresheets with iPhone or iPad. Results are calculated by MakeReady, but data can be easily exported to WinMSS. You should make a new match on www.makeready.info, add stages, get match PIN code and you're ready to go. App helps to avoid input errors and fully eliminate paper scoresheets. Data sending in real-time. Stats avoid dumb work for paper-to-computer manual input and can be more concentrated on validity checking and other stats work aspects. App can work in offline mode, when internet is present only in stats office wifi spot, for example. For an extra data protection all signed by competitors scoresheets are stored in local media gallery as screenshots.

Power Factor Calculator will calculate: - Power Factor, - Average Velocity, - Velocity Spread. Also would be shown the minimum and maximum velocity from the Velocity Table data. To calculate the Power Factor you have to enter the Weight of projectile in grains. Then add the velocities(in ft/s) to the table by specifying the velocity, and pressing the "Add" button. Thereafter all velocities was added to the table, press a "Calculate" button to perform the calculations. You can remove the particular value of velocity by swiping left. Or clear all Velocity Table by pressing the "Clear" button. To clean up all the data, press the "Reset" button.