Active+ Mobile vs ConfigR

This app is for adjusting settings in the Helvar Active+ lighting solution. To use this app, you must have an approved smartphone running iOS equipped with an LED flash, a luminaire fitted with an Active+ LED driver, and the Active+ Sense sensor. Settings that can be adjusted are: - Lights on and Power Save light levels - Occupancy time-outs - Fade times - Transition time-outs - Daylight dimming ranges - Bright-out functionality The app uses the smartphone’s LED flash to send data to the Active+ driver via the Active+ Sense light sensor. The smartphone must be within 70cm of the Active+ Sense sensor with the flash pointing directly at the sensor. Do not point any other light sources at the sensor while adjusting the settings. The luminaire light source LED will flash once when the settings have been received and stored. WARNING: This app uses high frequency LED light flashes. Notice: Active+ application is designed to work with a wide range of devices but may not be fully compatible with all phone models due to variations in hardware and software

ConfigR will seamlessly allow you to seamlessly install, commission and maintain heating systems. You can assist with any set-up, maintenance, and so much more: • View error codes • Diagnostic reports • Download and apply software updates To find out if your products are compatible to the ConfigR app, please go to https://www.dimplex.co.uk/en-gb/products/smart-controls/configr.