Sci vs Mobile Oscilloscope

一、Basic Description 1、This software is mainly used in the digital experiment of primary and middle schools, including physical, chemical and biological experiments. 2、To work properly, the software needs to be used with sensors and bluetooth transmitter modules (sensors are connected to bluetooth launch modules). The sensor data is sent to the receiving end of the iPad or iPhone via a connected bluetooth module. 3、The software operates on portable mobile devices such as iphone or ipad, which has bluetooth low power consumption of BLE 4.0. The software can actively detect and connect bluetooth devices, real-time data collection, analytical sensor data, digital、graphic display digital and graphic display, with functions such as plug and play, automatic recognition ( sensor ), parallel acquisition, combination drawing, free coordinate, line analysis ( fitting, integral, etc. ), table record, add variables, formula, table data drawing, etc. 4、The overall design of this software adopts the Qt5.12.0 technical framework and Objective-C mixing method. 二、Use Instructions 1、Access the Bluetooth transmitter module to the sensor , turn on the power on the Bluetooth transmitter module, and then the indicator light is on. 2、Start the software on the ipad or iphone. 3、The software initial startup interface is QR code scanning interface. The ID information of the device can be automatically scanned and displayed by a QR code that is pasted on the target bluetooth module in the various bluetooth devices that are enabled, which can support scanning of 4 bluetooth modules ( that is, up to 4 sensors at the same time ),after the scan is completed, click start experimental button start scanning, discovering, connecting bluetooth equipment, sensor data transmission, data display and analysis. For easy control, it is recommended that the software be installed on the device with a screen of 4.7 inches and above. Please ensure that the operating system version is iOS 11.0 or above.

This application turns your phone into a powerful handheld oscilloscope for audio signal analysis (professionals can also use for circuit analysis). The signal parameters can be displayed in detail, including: maximum value, minimum value, average value, effective value and frequency, and the frequency measurement is very accurate. There are multiple trigger modes. The trigger modes are: automatic mode, normal trigger and single trigger; the trigger edges are: rising edge trigger, falling edge trigger, rising or falling edge trigger, jump trigger and differential trigger; the trigger value can be selected. With the measurement function, it is freely measured in the horizontal and vertical directions, gesture operation, easy to use. Waveforms can be freely zoomed with gestures or buttons. Supports interface color selection. Has a storage depth of 10 seconds. This application is normally used for audio signal measurement without any risk. Circuit measurement special instructions: Professionals can use this application for circuit measurements and the electrical signal is input via the microphone channel of the headset. Please pay attention to safety: You must have enough professional knowledge. The high voltage circuit must go through the isolator and attenuator. Conventional low-voltage circuits must also add an attenuator and then enter the phone. Circuit measurement is risky and the author of this application will not be liable for any loss of personnel or equipment resulting from the correct or incorrect use of this application.