FRANK ElectroFusion Studio vs Mtouch

The FRANK-ElectroFusion Studio app captures quality relevant data during the preparation of PE / PP pipes for the electro fusion welding process. The BARCODE function decodes and shows the contents of barcodes conform to ISO12176-3 (fusion operator badge), ISO12176-4 (traceability code), ASTM F2897 (component code) and ISO13950 (fitting welding barcode). The WELDING function captures data during the preparation of the welding process following a pre-determined profile, e.g. job code, joint code, photos of quality relevant steps, GPS-data, system barcodes etc. Welding parameters will be transmitted via bluetooth connection (BLE) to compatible electro fusion controllers (processors) and the welding process will be started. The welding process data can be monitored within the range of the bluetooth connection. After the welding process is finished the device log in transmitted to the Smartphone and added to the captured data. After uploading to the server database the data can be reviewed on the EFCC-WepApp (ElectroFusion Control Center) by a limited group of people. Read more on http://electrofusion.de App languages: DE, FR, EN, PT, ES, IT, PL

---Control all MTouch regulators with your smartphone. Through this app you can control from your smartphone all the controllers Micon Mtouch connected to the internet. Check in real time all the measure parameters and the alarms status Enable and disable fluximeter and level sensors input Edit the setpoint programming for all the measures Edit the analog outputs programming Check hardware and software info of the controller A strip on the display indicates the ongoing operations: Green - regulator connected Red - regulator not connected Yellow - regulator waiting for an answer (after an editing operation) ---Server connection and security. All the MTouch regulators are connected to Micon server, which allows the communication with the smartphones. Through an easy list memorized on your smartphone you can pass from a regulator to another, quickly and safely. It is very easy to connect a regulator, you have only to add a new regulator to the menu, enter an easy nickname, enter the related serial number of the connected controller (this figure corresponds to the serial number printed on the regulator label) and finally enter a password. On the menu it is possible to add, edit, delete controllers from the list, enable the modification of parameters in order to avoid unintentional errors while scrolling through pages. ---Notes. To make a remote connection it is necessary that the MTouch is connected permanently to a wireless Internet network. In the absence of a connection password, all the information related to the regulator can be visible to all users who are using this app and who connect to a valid serial number.