Flexcon PA vs Parking Heater Remote

The Flamco Flexcon PA pressure assistant monitors pressurization of heating systems. The Flexcon PA periodically measures system pressure and stores the measurements in a log file. In collaboration with this app it analyzes system functions, assisting the installer and end-user in (preventive) maintenance tasks. With the app it’s possible to: - Calculate the correct fill-pressure and expansion vessel size - Load, analyse and share log files - Schedule any periodic maintenance interval - Monitor pressure levels, leak detection, expansion vessel end of life span - Configure the Flexcon PA and Flexcon PA AutoFill - Remote control the Flexcon PA AutoFill - View the instruction manual - Update the Flexcon PA firmware - Protect the installer settings by a login/password End-user view with: - Instructional video how to easily top-up the heating system - Easy to use expansion vessel sizing and safety valve calculator - Contact details of the installer - Share log file with the installer for remote support

Parking Heater controls your Webasto parking heater with ThermoCall TC3 or TC4 via SMS – now also Eberspächer with EasyStart Call (Beta) – and turns it into a proper app: start, stop, timer, status and temperature with one tap. The heater’s replies are evaluated and shown in the app, in widgets and on Apple Watch. CONTROL • Start, stop, status and temperature with one tap • Timer for your departure time – with Heating Time Management (HTM) the heater calculates switch-on time and duration itself • Set run time, comfort level, auxiliary output and temperature alarm • Eberspächer EasyStart Call: start with run time, target temperature, ventilation, timer and weekly schedule (Beta) • Setup Assistant: guides you step by step through the connection test and the module’s settings • Confirmation before starting and changing settings, can be turned off • Send automatically via a shortcut – no detour through the Messages app UNDERSTAND REPLIES • Reply SMS from the heater are evaluated: state, remaining time, cabin temperature, battery voltage • Live Activity on the Lock Screen and in the Dynamic Island while the heater is running • Notification when the run time ends and warning on low battery voltage • Battery trend: detects when the voltage keeps dropping day after day WEEKLY SCHEDULE • Departure time per weekday, pause for holidays or home-office days • Heat only when cold: weather forecast for where the car is parked (Open-Meteo) • Calendar: departure before your first appointment, optionally with travel time from Apple Maps • Start check: verifies shortly before departure that the timer really fired • Preview of the next 7 days AT A GLANCE • Widgets for the Home and Lock Screen, controls in Control Center • Apple Watch app with complication • History with battery voltage, temperature, heating statistics and fuel costs • Keeps an eye on the heater SIM’s credit and warns before it runs out • Sync between iPhone, iPad and Watch via iCloud • Siri: “turn on Parking Heater” REQUIREMENTS • Webasto parking heater with ThermoCall TC3 (firmware 3.2 or later) or TC4 (SMS control) and a SIM card in the unit – your iPhone must be registered there as an authorized number • Or Eberspächer parking heater with EasyStart Call and a SIM card in the module (Beta) – the app sends the module’s PIN along or registers your iPhone as the main number • Every reply from the heater is an SMS – charges may apply depending on your plan • Automatic sending and evaluating use Apple’s Shortcuts app; the in-app guide explains every step • Ready-made shortcuts to add are available on the support page: www.bumberger.at/en/standheizung This app is an independent project and is not affiliated with the Webasto Group or the Eberspächer Group. Webasto and ThermoCall are trademarks of Webasto SE; Eberspächer and EasyStart are trademarks of their respective owners.