Sensor Configuration vs aleoBlue Lighting Controls

Configure, test and adjust Legrand Bluetooth™ enabled sensors from your mobile device, leaving your ladder behind! The Sensor Configuration app from Legrand, allows users (electrical contractors, installers, or facility managers) to easily manage outdoor Bluetooth™ Low Energy (BLE) sensor installations despite difficult weather, direct sunlight, height restrictions and other physical obstructions. No other specialized or additional hardware or tools are needed. Not only is it easier to configure than before, sensors are also faster to set up than ever before and end-users will know that their Bluetooth enabled wireless fixtures are secure in a mobile environment. No cellular service? No Wi-Fi? No worries. Once the app is installed, our use of BLE allows you to make adjustments to your Bluetooth enabled sensors anytime - offline and off the grid. Features: -Supported Sensors: FSP, FDP - Bluetooth device discovery with bidirectional communication - Basic sensor parameter settings include: high mode, low mode, time delay, cut off, and sensitivity - Advanced sensor parameter settings include: hold off, ramp up, fade down, and photocell - DALI supported parameters including: fade time, fade rate - Firmware updates - Editable profiles (reusable groups of parameter values for quick reuse fixture to fixture) - Password protected jobsite management - English, Spanish and French - Free to download

Lighting industry is going wireless and the number of ready-to-use products is growing rapidly. To unleash the full potential of smart lighting networks, aleoBlue provides a set of tools for commissioning and monitoring qualified Bluetooth mesh lighting devices. Using our intuitive web and iOS apps, you can customize lighting control parameters in accordance with site-specific needs and building energy codes. All of that without specialized training or lighting control expertise. Complete the commissioning process on-site with the use of our iOS app. It allows you to add Bluetooth mesh lighting devices to a wireless network in no time. Its intuitive interface was designed to require as little work on your side as possible. Provisioning Thanks to proximity sensing, the app provides you with a list of detected lighting devices. Provision up to 5 devices at once. Using a RSSI filter, you can narrow down the list of visible luminaires to those that are the nearest Customization If you find it necessary, you can customize the previously selected scenario to your needs. Personalize run, prolong, and standby modes plus other lighting control parameters. Calibration Calibrate a light sensor in accordance with the measure provided by a light meter. Adjust brightness until it reaches the desirable level and enter the value. Test Test the performance of lighting control as well as the defined lighting scenes and make adjustments if needed