soundfruuze vs Tone Gen Studio

'soundfruuze' is an exprerimental live sampler / looper / granular and FFT scrub effect It records live the recent 10 seconds of audio and allows you to manipulate it with special controls. The interface is divided into five “lanes”, sound is produced by touching the lanes. Each lane can be set up to use different effect and has various control parameters mapped to the touch position: Scratch Most basic lane type. You can control the volume of the resulting sound and smoothness of the position interpolation. Lesser smooth value produces the sound with more high frequencies. Speed Another basic playback type. Starts playing from the position in the sound that you selected with touch. Vertical position controls playback speed, horizontal parameter is assignable. Granular Freeze Allows you to select the sound at some position and use both horizontal and vertical coordinates of touch as 2 independent parameters. You can control volume, playback speed (pitch) and the grain size. Granular Scrub This type of lane is very similar to granular freeze but it allows to change the position of the grain after its start. Granular Stream This lane type enables granular playback with random parameters. You can randomise grain position in the selected range, speed, grain size and pan. There is special control for that type lane. The 2-dimensional slider is assignable so you can change 2 parameters for each touch independently. FFT Freeze and FFT Scrub In both FFT types of lanes another algorithm is used to process sound. In both FFT Freeze and Scrub sound is analyzed with the FFT transform and divided into frames. FFT Freeze allows you to select the frame at the desired sample position and to play it making the sound “freeze” at this point. Looper This lane type allows you to make loops / repeat large grains of sound. When you touch a looper lane, a new looper control is created and is kept there until you turn it off with the red ‘close’ button. You can change loop speed, volume, size and position for each loop individually or for all loops on one lane together using additional controls FFT Looper This type works the same way as basic Looper but allows to change playback speed while keeping the pitch. It uses FFT algorithm for playback allowing constant pitch for any playback speed and the same FFT effects (gate and phase randomisation) Each lane has also five effects: - Frequency shifter - Ring modulation - Sample-and-hold (" lo-fi") - HP/LP filter - Reverb

Test speakers, find frequencies, tune instruments, and keep time during practice with Tone Gen Studio. Generate tones, sweeps, and noise, explore your microphone input with the tuner and spectrum analyzer, or practice with the built-in metronome. Tone generation and speaker testing - Set a custom frequency or choose a preset tone pad. - Select sine, square, sawtooth, or triangle waveforms. - Run linear, exponential, or stepped frequency sweeps. - Generate white, pink, and brown noise. - Set burst on and off durations for pulsed tones. - Adjust binaural carrier and beat frequencies for headphone playback. Tuning and audio analysis - View the detected note, frequency, and cents with the microphone tuner. - Explore input levels with a real-time spectrum analyzer and 1/3-octave RTA bands. Metronome and practice - Set a tempo from 20 to 300 BPM or use tap tempo. - Choose time signatures, subdivisions, accents, and five click sounds. - Practice with swing, polyrhythms, gradual tempo ramps, and random mute. - Use a count-in and practice timer. Start at a low volume and adjust gradually. Binaural playback requires headphones. Speaker response and microphone measurements depend on your device and connected audio equipment. For musicians, audio engineers, educators, and anyone working with sound on iPhone and iPad.