RS vs ClearNode

"RS-R30I" is a remote control application for the ICOM Wideband Handy Receiver "IC-R30." You can operate and change the receiver’s settings using an iPhone or iPad, and you can also check its settings. Device requirements: iOS version 9.0 or later for 64 bit CPU models. Supported receiver: Icom IC-R30 Refer to the instruction manual for details. NOTE: - The RS-R30I does not guarantee compatibility with all iPhones and iPads. It may not work, depending on its OS version, installed applications, and so on. - Confirm the IC-R30's Serial port function is set to"CI-V (Echo Back OFF)" ( [MENU] > Bluetooth Set > Data Device Set > Serialport Function ) - Bluetooth LE is used to connect with the IC-R30 and it is a slow data transfer. So there may be a time delay between the receiver’s operation and the display on the data device. In addition, depending on the receiver environment, it may not be able to operate properly. - Bluetooth may be disconnected in the following cases: · The screen of the device is locked. · The application is running in the background mode. · Wi-Fi is enabled. · Connecting or removing a Bluetooth headset.

The ClearNode App allows you to: - Set up your ClearNode with your AllStar, Echolink and DMR credentials and settings - Configure important parameters for Asterisk and USB Audio - Connect and disconnect your ClearNode device from remote nodes and servers - Keep a catalog of the nodes you have connected to - Search the AllStar, Echolink and DMR active node lists - Control the integrated radio: Tx/Rx frequency, CTCSS codes, Squelch, Volume, Emphasis, High Pass and Low Pass, bandwidth - Power down or reboot your ClearNode Device - Play a delayed stream (~20 sec) of the audio traffic on your ClearNode (Tx and Rx), also play the stream to your public Broadcastify account - The ClearNode App detects and displays your ClearNode's current IP Addresses - If you have multiple ClearNode devices you can monitor and control them all from a single ClearNode Mobile App This application is a support/remote control utility for ClearNode devices built by Gerry Filby/W6WNG.