PowerMeter vs Liverage Power Meter

1. Basic function page (welcome page/connection matching/technical support)        Welcome page: Once you enter the smart meter app page, you will automatically jump to the next page after the app is launched.        Connection pairing: APP guide the user to open the search for the Bluetooth device, and the search results are displayed in a list.        Technical support: Service users at any time, put customer service functions in the system interface to facilitate user assistance. 2. Communication parameter settings Different connection modes contain RS-485 or Ethernet can be set for different environments. Such as the baud rate, the same bit, the data bit, the stop bit, the IP address, the subnet mask, and the gateway address, Modbus TCP connection port, and other different parameters. 3. Phase line parameter setting Different parameter settings can be made for four wiring types such as 1P2W, 1P3W, 3P3W, and 3P4W. Each setting item needs to be adjusted according to the physical wiring system and C.T. serial connection mode, and should be paid attention to the correctness of the serial connection mode of each interface. 4. C.T. parameter setting The APP provide 333mV and 5A equalizer parameter settings and users can confirm whether the current matches the set value. 5. Other functions If necessary, users can also reset the hardware directly (all parameters are restored to factory settings).

The Liverage’s Meter is mainly used for checking the signal output powerThe Liverage’s Meter is mainly used for checking the signal output power of the optical communication equipment in fiber optic networks. It measures the average power of a continuous light beam which is emitted from the equipment or other optic sources. It measures power in 850 nm (Multimode) and 1310 nm / 1550 nm (Single mode) respectively. The Fiber Meter consists of a solid state InGaAs photo diode, signal power measurement circuitry, and a 3 Digits LED display. Users just connect a fiber cable between the transmission port of the equipment and the universal interface on the Fiber Meter or connect to other light source. The product will show the exact amount of the received power (in dBm). The universal connector can be used for all the most common fiber interfaces such as ST / SC / FC and it is suitable to test both Single mode and Multimode cables. With an optical 2.5 mm to 1.25 mm adapter, users can even test for 1.25 mm fiber interface. Download the Liverage official Power Meter APP, and get the IOS support version >= 9.0] mobile phone with Bluetooth could allow consumer to display the function of the Power Meter APP. Power Meter App functions: Reference function、switch measurement data for dBm/mW、save testing results and upload to Cloud、battery for Power Meter.Power Meter App functions: Reference function、switch measurement data for dBm/mW、save testing results and upload to Cloud、battery for Power Meter.