Waylens Fleet vs Pixel Mapper xModel

The Waylens fleet app is the onboard companion to the Waylens fleet camera. Verify Installation
Step-by-step installation verification makes it easy for installers. Steps include: 1. Power wiring check (for direct, 3-wire installs) 2. Video Check to ensure the placement and angle of the camera is properly set 3. FW check to ensure the camera is up to date 4. LTE check to ensure the camera is connected to the network 5. Aux camera check to verify placement and video stream
 Review, Extract, and Share Historical Video Fleet Managers can connect to the camera to review historical video from the SD card. Once a video segment of interest is found, they can choose to share it from their smartphone. Filtering capabilities make it easy to identify risky events requiring review, saving managers from sifting through hours of historical video. Maintain, Troubleshoot, and Verify Camera Operations Full menu of performance tests that can be used to: 1. Check LTE network 2. Check Power cord wiring 3. Review SD card usage 4. Provision APN, if applicable 5. Check vehicle battery voltage 6. Submit camera logs for support 7. Review aux camera video stream, configure proper orientation

Pixel Mapper turns your iPhone or iPad into an automatic layout tool for xLights. Point your camera at your light display, and the app lights each WS2811 / WS2812 pixel, finds it in the camera image with computer vision, and builds a ready-to-import xLights Custom model — no manual clicking pixel by pixel. Perfect for Christmas light displays, props, matrices, megatrees, and any irregular pixel layout that's painful to map by hand. HOW IT WORKS 1. Target — enter your controller's IP and pixel count. Output goes over DDP or sACN / E1.31, the same protocols xLights and FPP already speak. 2. Scan — choose a mode: • Fast (base-3): every pixel lights in every frame, colored by one base-3 digit of its index, so all pixels are identified in only ~log3(N)+2 frames (about 500 pixels in 8 frames). Two checksum digits reject misreads. • Sequential: light one pixel at a time and find the single bright blob. Slower, but dead simple and rock solid. Both modes subtract a black reference frame to ignore ambient hotspots. 3. Review — see the detected layout over your photo, drop bad points, tap to place or move a node, and re-scan individual pixels. Zoom and pan to fine-tune. 4. Export — save a standard xLights .xmodel file that imports into both old and new versions of xLights. WHY PIXEL MAPPER • No more mapping hundreds of pixels by hand. • Works with the gear you already own — any DDP or sACN/E1.31 pixel controller. • Fast base-3 scan maps large models in seconds of capture. • Checksum-protected so misread pixels get rejected, not placed wrong. • Best results in a dim room; the app locks camera exposure and focus where the device supports it. REQUIREMENTS • A WS2811 / WS2812 (or compatible) pixel controller reachable on your network. • The controller set to receive DDP or sACN / E1.31. • An iPhone or iPad on the same Wi-Fi network as the controller. Pixel Mapper is an independent tool and is not affiliated with or endorsed by the xLights project. xLights is a trademark of its respective owners.