WoodScaper vs Tone Gen Studio

WoodScaper combines into one unit the 4 classic guitar effects : phaser, chorus/flanger, wah-wah and tremelo. Besides the familiar controls each effect has some extra not-so-commonly-found options. The 4 effects can be routed in series (pedalboard mode), parallel (DAW mode) or some combinations of those modes. Panning or the Stereo control can create stereo sounds from a mono input source. WoodScaper is both stand-alone and an AUv3 effect. - All LFO’s can be set to different waveforms : Sine, Square, Saw Up, Saw Down, Triangle.
 - All LFO frequencies can be set to a bar fraction (1/4, 1/8 , …) of the BPM or can be set free to a specific rate   (independent from the BPM).
 - All LFO phases can be reset with a button.
 - All effects have an On/Off (parallel routing) or On/Bypass (serial routing) switch like on a pedalboard. The switches can  be toggled by Midi CC’s.
 - Phaser has settings for number of poles, frequency range and modulation flavour.
 - Phaser has second LFO to modulate filter Q.
 - Chorus has feedback, HighPass, LowPass and Saturation.
 - Wah-wah control can be LFO, Envelope, Envelope + LFO, side chain, Midi note velocity or Midi CC 1 (mod wheel).
 - Wah Envelope has Attack, Release and Threshold or Sensitivity controls.
 - Wah can go up or down.
 - Wah filter type and Q can be set.
 - Tremolo has 3 types : Amplitude, Ring or Harmonic.
 - Harmonic Tremolo has cross-over frequency control.
 - Tremolo has a Threshold control to have more tremolo when the signal increases.
 - Tremolo has “Biased Tremolo” mode to get more tremolo when the signal decreases.
 - Has a global Input and Output Gain control.
 - Has 2 extra LFO’s to modulate most parameters (rates, depths, …)
 - Modulation LFO’s have their own slew rate control and a random mode.
 - Presets can be stored in iCloud Drive (makes them available on all your devices).
 - Presets can be switched with Midi Program Changes or a Midi CC (up or down)
 - Major controls can be set with Midi CC messages.

Test speakers, find frequencies, tune instruments, and keep time during practice with Tone Gen Studio. Generate tones, sweeps, and noise, explore your microphone input with the tuner and spectrum analyzer, or practice with the built-in metronome. Tone generation and speaker testing - Set a custom frequency or choose a preset tone pad. - Select sine, square, sawtooth, or triangle waveforms. - Run linear, exponential, or stepped frequency sweeps. - Generate white, pink, and brown noise. - Set burst on and off durations for pulsed tones. - Adjust binaural carrier and beat frequencies for headphone playback. Tuning and audio analysis - View the detected note, frequency, and cents with the microphone tuner. - Explore input levels with a real-time spectrum analyzer and 1/3-octave RTA bands. Metronome and practice - Set a tempo from 20 to 300 BPM or use tap tempo. - Choose time signatures, subdivisions, accents, and five click sounds. - Practice with swing, polyrhythms, gradual tempo ramps, and random mute. - Use a count-in and practice timer. Start at a low volume and adjust gradually. Binaural playback requires headphones. Speaker response and microphone measurements depend on your device and connected audio equipment. For musicians, audio engineers, educators, and anyone working with sound on iPhone and iPad.