AnchorChainCalculator vs easy2

Rather than following generic and unspecific advice how much chain or rope to pay out when at anchor, use this app to calculate the right amount of chain or rope needed for the anchor to have the best possible grip – safety tailored for your vessel! This app has been developed by a sailor living at anchor. It is based on physics rather than rules. Only too often does anchoring advice boil down to: Use a scope (i.e. ratio of chain length to water depth) of 3:1 in calm weather, and increase this to 5:1 or 7:1 as the wind picks up. This advice is independent of your vessel’s characteristics, independent of water depth, swell, or even the wind strength. So, is a scope of 7:1 still good enough for the storm tonight? Is the snubber or bridle you are using good enough to keep you safe at anchor? The Anchor Chain Calculator allows you to calculate the minimally required anchor chain and/or rope length based on a number of vessel characteristics and sea / weather conditions. It tells you what load the anchor will have to bear, and when you are using a snubber, bridle or rope, how much of the swell it absorbs, and how much it reduces the anchor load. When anchoring in shallow water it is particularly important to include these dynamic and elastic effects caused by strong swell and gusts. The app can work with a chain-only scenario as well as with an arbitrary mix of rope and chain. So, despite its name, it can also deal with a rope without any chain at all. ;) You can also restrict the chain or rope length, if you have to - perhaps because of nearby neighbours or obstacles - and get information how this restriction affects the anchor load and the angle at which the chain pulls at the anchor. The app has two modes of working: Basic Mode and Expert Mode. With Basic Mode you will be able to use the app right away, whilst Expert Mode allows you to enter more technical details of your boat if you know them. You can use either metric units (metres, daN / kp, and mm for chain thickness) or imperial units (feet, lbs, and inch for chain thickness). You can store different vessel configurations by name and so can easily switch, e.g., between different snubber, bridle, rope or vessel setups (e.g., a snubber for the lunch stop, another snubber for normal usage, and a third longer and even more elastic snubber for really bad weather). These setups can be locked to prevent accidental overwriting. This app is also great for playing through all kinds of "what if?” scenarios. It will help you to plan ahead and be better prepared. The perfect addition to an anchor alarm / anchor watch for safer anchoring!

With this app you can configure the newest generation of Man-over-Board Transponder "easy2-MOB". Via Bluetooth LE you can enter MMSI of up to 8 motherships which will be alerted in case of emergency. A detailed information on the Self-Test (DSC Acknowledgment and GNSS (GPS) receiver and the status of the internal battery is shown by the app. When the transponder was activated in case of emergency, the app can read out the date, time and position of this event like a "black box". Up to eight events are stored in flash memory an are listed in a table. The app provides a map view to show these Maritime Survivor Locations.