Caravan Leveler vs RigSteady

Stop running in and out of the door to check the level. Caravan Leveler turns your iPhone into a levelling sensor that tells you exactly what to do: which side to raise, which end, and by how many centimetres — then lets you read it from wherever you are standing. KNOW EXACTLY WHAT TO RAISE - Front and side silhouettes of your vehicle tilt in real time, with the angle to a tenth of a degree - Plain instructions: "Raise the right side ≈ 6.3 cm", then "Raise the front ≈ 2.4 cm" - Side to side first, then front to back — the order that actually works MADE FOR CARAVANS AND MOTORHOMES - Caravan: wind the jockey wheel up or down and chock a side — the app says which way and how far - Motorhome and autocamper: it knows you can only drive onto ramps, so it only ever asks you to raise, and names the wheels - If the ground is too steep for any ramp, it says so instead of quoting a number no ramp can reach - Air suspension? It reminds you to let it settle before you trust the reading SEE THE MOMENT YOU'RE LEVEL - Silhouettes, spirit-level bubble and readout all turn green when you get there - Choose the silhouettes, the bubble, or both on one screen - Drive-on guidance beeps faster as you approach level and chimes when you arrive, so your eyes can stay on the ramps. It ducks your music or radio instead of stopping it READ IT FROM OUTSIDE - Leave the sensor iPhone inside, flat on the floor or a worktop - A second iPhone or iPad connects directly and shows the live level — no Wi-Fi, no internet, no account - Or check it on your Apple Watch while you wind the steadies - Your vehicle type and display choice follow along to every device automatically - Streaming from the sensor iPhone to a Watch or second device comes with a Week Pass, Season Pass or Annual Premium, after a 24-hour trial. Levelling on the iPhone itself, and the display device, are always included MEASURE ONCE, RAISE EXACTLY - Two quick tape-measure readings — between the wheels, and from the wheel to the front support or across the wheelbase — turn degrees into centimetres - A visual guide shows exactly where to hold the tape CALIBRATE ON ANY SURFACE - If the surface under your iPhone isn't quite parallel to the chassis, level the vehicle once and hold to calibrate - Reset it with a tap whenever you move the phone AND A FEW MORE THINGS - Sun direction: see where the sun is relative to your vehicle, and park for shade or solar - Siri and Shortcuts: switch vehicle type, turn drive-on guidance on or off, change mode and calibrate by voice - In English, Danish, German, Dutch, Norwegian and Swedish Terms of Use (EULA): https://www.apple.com/legal/internet-services/itunes/dev/stdeula/

Stop guessing how many leveling blocks to stack. RigSteady estimates the blocks needed for each wheel of your RV, motorhome, or travel trailer using your iPhone sensors and your vehicle's dimensions. You know the routine: park the rig, place a bubble level, guess the blocks, drive up, check, repeat five times. Couples argue. Solo travelers climb out of the cab over and over. LEVELING SOLVED IN SECONDS • PRECISE BLOCK COUNT — Enter your wheelbase and track width. RigSteady converts tilt into physical leveling blocks for each wheel. • VOICE GUIDANCE — A real-time voice assistant guides you while you drive onto your blocks. No spotter needed. • 100% OFFLINE — Works deep in the forest with zero cell service. • VEHICLE PROFILES — Save dimensions for every rig you own. • CAMPSITE LOGBOOK — Record each site with its leveling setup for next time. BUILT FOR REAL CAMPERS RigSteady focuses on one job: clearly showing which wheels to raise and how many blocks to try. No subscriptions. No ads. No extra hardware sensor. Just your iPhone, your vehicle dimensions, and clear guidance in seconds. Spend less time checking and adjusting, and more time enjoying your campsite.