Clean Wave vs Speaker Cleaner · Water Eject

Sound muffled after rain, a swim or a shower? A few drops of water may be sitting in the speaker grille. Water Eject plays low-frequency tones that make the speaker vibrate, which can help push small water droplets out of the grille. HOW TO USE WATER EJECT 1. Turn the volume all the way up and disconnect headphones. 2. Place your phone screen down on a towel or tissue. 3. Pick a cleaning mode and tap Play. If the sound is still muffled, run another short cycle. FEATURES • Water Eject: 10 cleaning modes with tones, bass pulses and frequency sweeps. Premium unlocks all of them. • Speaker test (Premium): test sounds such as a frequency sweep, bass, stereo and piano clips, to hear how your speakers sound. • Noise meter: live sound level readings. Values are estimates, not a calibrated decibel meter. • Tone generator (Premium): play any frequency in Hz with sine, square, triangle or sawtooth waves. TIPS • Hold the phone with the speaker facing down so droplets can drain out. • Run two or three short cycles rather than one long one. • Let the phone dry at room temperature afterwards. Do not use a hair dryer or heat. • If the noise meter cannot access the microphone, allow it in Settings > Privacy & Security > Microphone. IMPORTANT Water Eject is meant for small amounts of water in the speaker grille after splashes or brief contact with water. It cannot repair water damage or remove water from inside your phone. If your phone was submerged or does not work properly, contact the manufacturer or an authorized repair service. Premium is optional. A subscription or one-time purchase unlocks all cleaning modes, the speaker test and the tone generator. EULA: https://www.cleanspeaker.app/terms Privacy Policy: https://www.cleanspeaker.app/privacy

Restore Crystal-Clear Sound with Speaker Cleaner Bring your device’s speakers back to life with Speaker Cleaner - the smart, safe, and effective way to remove dust, dirt, and moisture from your audio system. Using precision-engineered sound frequencies, the app helps restore full, powerful sound quality in just minutes. Key Features: • Advanced Frequency Cleaning – Generate sound waves from 0 Hz to 20 kHz to break down and expel unwanted particles. • Automatic Cleaning Mode – Sit back while the app runs a pre-programmed sequence for optimal speaker recovery. • Manual Cleaning Mode – Take control with customizable frequencies and durations for targeted cleaning. • Stereo & Audio Tests – Check left, right, and full-range output to ensure your speakers are working perfectly. Pro Tips for Best Results: • Place your device face down on a flat surface. • Set your volume to maximum. Get rid of muffled audio and enjoy crisp, high-quality sound again. With Speaker Cleaner, your speakers will always sound their best. Privacy Policy: https://www.belkalabs.com/privacy Terms of Use: https://www.belkalabs.com/terms