UPSnut Pro vs TrafficAuth

UPSnut Pro can be used to retrieve UPS status information, like battery charge level, battery voltage, time on battery and so on, from an UPS with a network management card (compatible with SNMPv1/v2c) or NUT (Network UPS Tools)/ APC UPS Daemon (apcupsd) server that has an UPS (Uninterruptible Power Supply) hooked up to it. Features: - App supports the latest NUT server / APCUPSD and is compatible with all iPhone running iOS 16 or higher. - SNMP Support for v1 and v2c. - Dark mode is supported. Requirements: - Any UPS compatible with NUT or APCUPSD or UPS with SNMP management (following IETF SNMP standard) - Server - this can be any device that can host the NUT / APCUPSD service (Note: you can not run the server on an iPhone, the phone is just the client. You can use an embedded device, such as a Raspberry Pi), Server not necessary if UPS has management card (and supports IETF UPS monitoring SNMP) - your phone For information regarding set up of the NUT server, please check the project's site: https://networkupstools.org And for information regarding set up of the APCUPSD server, please check the project's site: https://apcupsd.org Support: UPSnut Pro (the iOS app) is a fully compatible, but unofficial client developed to allow your device to connect to NUT / APCUPSD servers. No support will be provided for bugs in NUT server or in APCUPSD, but only for bugs related to this iOS app. Tested on CyberPower UPS, no affiliation with cyberpower or APC or any UPS manufacturer.

Monitor active work zones for dangerous transitions of the work zone boundary by either the active work zone worker on foot, or by passing vehicles. The worker will receive notifications of the hazards, as well as users in a vehicle will receive notifications to be aware of the work location boundaries.