SmartView Device Interface vs KGateway

The SmartView app is used for controlling the Senticon's Intelligent Room Controllers and Smart Room Sensors. With the SmartView app you can change your room settingsand monitor the room measurements. For example with the TCR/QCR controllers you can change the (heating/cooling) setpoint, operating mode (occupied/unoccupied/night), fan speed and analyse the current demand. The SmartView app connects to the device using Bluetooth connection of you iPhone/iPad. Once connected to the device, and if first time, the SmartView interrogates the device and automatically builds the view required to control your room. Once the configuration has been created, next time upon connection you can immediately start to change the settings.

KGateway is a configuration app, through which you can configure the BLE/Wi-Fi gateway launched by KKM. This app supports configuration of the following parameters: 1. Wi-Fi connection information. 2. BLE scan parameters, filter parameters. 3. HTTP or MQTT server information connected by the gateway. After provision by the app, the gateway(BLE/Wi-Fi) can connect the BLE Beacon/Sensor devices, and can report the sensor data from Beacon/Sensor devices to the cloud. Why does this app need location permission? Because the app needs to scan the SSID information of the KGateway when configuring the KGateway for the first time, and the location permission is required for IOS to scan the Wi-Fi SSID information. Why does this app use the HTTP not HTTPs protocol? This app only uses HTTP protocol to connect to the KGatway(WiFI-BLE gateway) for provision. Because the KGateway's internal resources are limited, the device only supports the HTTP protocol. In addition, because the app will only perform provisioning when the KGateway is used for the first time, and the app and the KGateway device must be under the same Wi-Fi router during provisioning, the security risk of using the HTTP protocol for Provisioning is controllable.