KGP NFC vs CDI NFC Tool

Application The KGP NFC app offer quick and easy configuration and analysis of KGP LED drivers. This makes the work of installation engineers, maintenance officers and employees in similar fields easier. Functions The following functions can be configured via the app, provided they are supported by the respective KGP products. Output current of KGP LED drivers: Set the LED output current (in mA) to adjust the brightness Device operating mode: Selection of the device operating mode (Push dim models, CLO models, etc.) DALI addressing: Set the DALI short address Corridor function: Configuration of the corridor function (light level, fade times, etc.)

CDI 40W Driver Programmer puts professional LED driver configuration in the palm of your hand. Designed exclusively for CDI 40W RFID/NFC LED drivers, this app allows installers, electricians, and lighting professionals to quickly adjust forward current settings on-site using any NFC-enabled iOS device. Simple, Tap-to-Program Operation No special equipment needed—just bring your smartphone close to the driver's NFC antenna and configure output current in seconds. The app communicates directly with the embedded ST25DV RFID chip inside each driver, allowing you to fine-tune light output to match your project requirements. Key Features Adjust forward current output to optimize LED performance and efficiency Read current driver settings including model information, date code, and output limits Intuitive slider and direct mA entry for easy current selection Instant verification confirms successful programming Works with all CDI 40W series RFID/NFC-enabled LED drivers Built for the Field Whether you're commissioning a new installation, retrofitting existing fixtures, or performing maintenance, this app eliminates the need for laptops, proprietary programmers, or complex software. Make adjustments on the spot and move on to the next fixture. Requirements - iOS device with NFC capability - CDI 40W series LED driver with RFID/NFC programming interface How to Use Open the CDI 40W Driver Programmer app Hold your device near the NFC antenna on the LED driver Read current settings or program new output current values Verify successful programming before moving to the next driver Download now and streamline your LED driver configuration workflow.