iRFR vs ArchMM

The iRFR from ETC provides a remote for any Eos family lighting system (Eos, Eos Ti, Gio, Gio @5, Ion, Element and Eos/Ion Remote Processors). This application requires Eos family software 2.6 or higher on the connected lighting system. Eos 3.0 or higher is required for Focus Wand Please note the iRFR is NOT support by Cobalt. The iRFR supports most features needed for programming and playback. It does not support remote patching and system configuration. A tab-based system changes the displays from the full keyboard, moving light controls, direct selects, playback tools and a cue list. Security controls prevent un-authorized access to a lighting system.

Scale, measure, and calculate with ArchMM. A practical calculator for designers, model makers, builders, architects, and students—built around feet, inches, fractions, and architectural scale. MODEL SCALE Convert full-size feet and inches to model millimeters for 3D printing and model making, or work backward from a model measurement. Choose 1:1 or common architectural scales and compare the converted length with a printer-bed preset. CARPENTER CALCULATOR Use dedicated number, unit, fraction, and arithmetic buttons. Add and subtract dimensions, multiply lengths into area or volume, recall memory, and revisit recent calculations. The next number after equals starts a new calculation. SCALE TO INCHES Enter a full-size measurement and get its scaled size in inches. Change the drawing scale at any time. PROJECT TOOLS Calculate board feet, explore a stair layout, and work out common-rafter geometry. Each tool explains its assumptions. These are geometry estimates, not structural design or code-compliance approval. MADE FOR EVERYDAY WORK • Copy results for your next task • Light, Dark, and System appearance • On-device calculations with no account, ads, analytics, or tracking • No internet connection needed for calculations Printer checks compare one converted length with the bed dimensions. Confirm the complete part geometry, orientation, and clearances in your slicer.