WeMorse vs RST Decoder

WeMorse is WABUN and International morse code training software. This is iPhone/iPad universal application. Usable morse code: WABUN morse code(Japanese) International morse code American morse code Changing Sound Parameters: Speed(5WPM to 40WPM), Frequency(100Hz to 2500Hz), Volume Sound wave form(5 kinds) Code length(Dot,Dash,Character space, Word space) Attack form and Release form of sound Functions: Generate training letters by define strings or from letters you define. Shuffle text by space delimiter Translate letter to morse code Changing Display mode during sending Shorten number and continuos code are shown by bracket off with inequality brackets. See Manual in Support HP. Because inequality brackets are not displayed for this description restrict. ex) shorten 1 is .- shorten 9 is -. continuos BT is -...- continuos AR is .-.-. You can register new codes you want and adjustable the length of dot and dash.

This is an App that decodes Morse code input from the microphone. It is a Morse practice App that you can use to check if you are keying the correct code. Signals with good S/N can be decoded correctly, but signals with bad S/N cannot be decoded correctly. Also, the performance will be degraded for extremely slow or fast signals. Usually about 5 to 10 characters are required for speed synchronization of Morse Code. Adjust the input signal so that the peak value changes from level 6 to level 7. Make fine adjustments to each parameter according to the reception status. [Additional Functions] -In addition to the decoder using BPF, a new decoder using FFT has been added so that it can be switched according to the usage. -AFD (Auto Frequency Detector) function has been added to the decoder using BPF, and BPF can be set automatically by pressing the AFD button. -The decoder using FFT automatically follows the strongest signal in the band by AFD (Auto Frequency Detector) and AGC (Auto Gain Control). You can also hold the AFD / AGC parameters by pressing the Lock button. * There will be a time lag of about 1 to 2 seconds for AFD tracking. [Control parameters] 1. Audio Input Level 2.BPF ON/OFF 3.BPF of Center Frequency 4.BPF of Band Width 5.CW Speed Control ON/OFF 6.CW Speed Control Low, Mid1, Mid2 or High 7.Delete All Decoded Text 8.Realtime CW Signal Display 9.Input signal recording / playback function *Japanese/KANA text is not supported. [Note] Since the signal after BPF is output to the audio output, it can also be used as an AF-CW filter. [URL of this App working example video] https://youtu.be/Pwp7W4m-m34