MySolArk Installer vs CurrentMate

MySolArk Installer is the official field tool for solar professionals who install and commission Sol-Ark hybrid inverters and battery systems. From creating a new plant to generating a final commissioning report, every step of the installation process is guided, validated, and documented — right from your phone or tablet. GUIDED COMMISSIONING WIZARD Walk through the Sol-Ark Setup Wizard designed for hybrid inverter and battery installations. Each step covers a critical phase of commissioning — safety checks, system topology, network configuration, hardware validation, battery setup, grid code compliance, energy management profiles, and time-based usage schedules. Pick up where you left off and track progress from your dashboard. NETWORK & CONNECTIVITY Set up WiFi or 4G LTE dongles to connect Sol-Ark equipment to the cloud. Configure network credentials, activate LTE service, and verify connectivity so every system stays online after you leave the site. COMMISSIONING REPORTS Generate professional PDF commissioning reports that document system configuration, hardware validation results, and post-install checklist completion. Reports are stored with the plant for future reference. PLANT MONITORING Monitor installed systems with power flow, energy production totals (daily, monthly, yearly, lifetime), equipment status, and event logs. Filter faults, warnings, and informational events to diagnose issues quickly. PLANT MANAGEMENT Create and manage plants with address, timezone, installed capacity, contact information, and site photos. Share plant access with homeowners via their MySolArk account. BUILT-IN SUPPORT Access Sol-Ark's Help Center with documentation, manuals, and direct contact to the support team — available from the dashboard and throughout the commissioning flow. DESIGNED FOR PROFESSIONALS MySolArk Installer is built for certified installers, site designers, and installation managers. A registered MySolArk account is required to sign in. Key capabilities: • Guided hybrid inverter commissioning wizard • QR code scanning for device registration • WiFi and 4G LTE dongle setup • Battery configuration (capacity, chemistry, protection) • Grid code and utility compliance settings • Time-of-use scheduling and peak shaving • PDF commissioning report generation • Real-time plant monitoring and event logs • Plant sharing with homeowner MySolArk accounts • Light and dark mode support For support, contact Sol-Ark at support@sol-ark.com or call +1 (972) 575-8875.

CurrentMate is a simple, fast tool built for electricians who just need answers quick, all in one spot. No clutter, just the stuff you actually use on the job. Calculators: Ohm's Law calculator Construction Calculator Wire sizing (continuous & non-continuous loads) Voltage drop (single & three phase) Transformer KVA wire sizing EGC / GEC / bonding Conduit fill (multiple wire sizes supported) Box fill (multiple wire sizes supported) Conduit Bending: 90° stub 90° Back-to-back Kick 90° Offsets Parallel offsets Rolling offsets 3 bend saddles 4 bend saddles Quick References: 3-phase circuit colors Ampacity table (75°C focused) Offset multipliers 90° bending reference (deduct & shrink) Rigid precut & thread formula RJ45 wiring (T568A / T568B) Built to be fast, offline, and easy to use in the field. Important: CurrentMate is a reference tool designed to support electricians in the field. It does not replace the NEC, local codes, or professional judgment. Results should always be verified before performing work. Use of this app is at your own risk.