RAUSI vs Simple NAM Chain

RAUSI is a dual-circuit high-gain distortion processor for iPhone and iPad. Use it as a standalone audio app or insert the included AUv3 effect in a compatible host such as GarageBand. FLOE and CRAG provide two contrasting distortion personalities inside one front panel. FLOE leans toward dense, abrasive wall-like saturation, while CRAG provides a tighter voice with deeper active EQ control for focused riffs and deliberate placement. FEATURES - FLOE and CRAG distortion modes - Adjustable Input, Drive, and Output - Active Low, Mid, High, and Mid Frequency controls - Selectable 9V / 18V headroom and saturation behavior - Instrument and line input modes - 2x and 4x oversampling modes - Standalone iOS/iPadOS app - AUv3 audio effect for compatible hosts TRY BEFORE UNLOCKING The working release model assumes 10 minutes of full-featured active use, shared between the standalone app and AUv3 extension. A one-time, non-consumable In-App Purchase unlocks unlimited use in both formats, with Restore Purchases available in the standalone app. Confirm this behavior in the production build before submission. RAUSI is designed for guitars, bass, synthesizers, drums, and parallel processing that need strong attack, dense harmonic weight, and controllable high-gain tone shaping.

Turn your iPhone or iPad into a guitar rig. Simple NAM Chain plays amp captures in the Neural Amp Modeler format, including A1 and A2. Load a capture, add a cabinet impulse response, and play. It runs on its own, or as an Audio Unit inside GarageBand, AUM and other hosts. BUILD A CHAIN Stack up to six blocks in series — a drive pedal into an amp head into a cab, or whatever order you want. Drag to reorder, bypass any block, remove the ones you don't need. Tag each one Full Rig, Amp Head, Pedal, Outboard or IR so the chain reads at a glance. EVERY BLOCK IS A FULL RIG Each block has its own input level, noise gate, amp capture, cabinet IR, three-band EQ and output level. The gate, the EQ and the IR each switch off independently. LOAD WHOLE MODEL PACKS Captures usually arrive as a folder holding the same amp at a range of settings. Point the app at the folder and step through every capture with the arrows, without going back to a file browser between takes. Keep your packs anywhere on the device, or drop them into the Full Rig, Amp Head, Pedal, Outboard and IR folders the app creates for you in Files. GAIN STAGING HANDLED Captures that carry calibration data are gain-staged automatically as you reorder the chain, so stacking blocks doesn't wreck your levels. Set your interface's input level in dBu once, and pick Raw, Normalized or Calibrated output. ALSO INCLUDED • Built-in tuner • Slim control, to trade a little accuracy for lower CPU on captures that support it • Live CPU readout • Recovers cleanly from phone calls, route changes and unplugged interfaces WHAT YOU NEED An audio interface to plug your guitar into gives the best results — the built-in microphone works, but isn't meant for playing. You'll need captures in .nam format (A1 and A2 are both supported), and impulse responses as .wav files if you want cabinets; thousands are free at tone3000.com. Headphones or monitors, so the mic doesn't feed back. FREE FOR THREE DAYS Everything is unlocked for three days. After that the app stops processing audio until you unlock it, which is a single payment of $4.99. Not a subscription, no accounts, no ads, and nothing is collected about you.