Prysmian Group Conduit Fill vs PullCalc

Prysmian Group’s Conduit Fill calculator is a quick and easy tool to calculate the minimum conduit size per National Electrical Code. It is designed for engineers, contractors, and other electrical professionals to find quick answers without spending hours on lengthy calculations. Features: Code Selection for NEC® 2011, 2014, and 2017. Metric or standard conductors Allowable fill rates for combination of conductors Calculates minimum conduit size for compact stranded conductors Over fifty different types of insulation Over ten different conduit types Results show total area required, nipple size, and minimum conduit size

Greenlee continues to drive efficiency with PullCalc, an app that helps electricians and contractors approximate the pull force needed to install an electrical cable inside of conduit. Data is entered by "legs" and each leg is considered to be a straight run of conduit followed by a bend, except the last leg, which usually has no bend. The calculation for each leg requires the following information to be entered: - Wire size - Number of wires - Conduit I.D. - Duct Material - Material of the Cable Insulation - Coefficent of Friction* - Length of Leg - Bend angle - Vertical Rise *Due to unknown factors involved, it prohibits giving exact results, most notably the coefficient of friction. Lubrication, surface texture, and lay of the cable are never uniform along the length of a conduit run. Comparing the known forces of pulls against the estimated force should give you a guide as for a good coefficient of friction to use for similar future pulls, and a table with some suggested starting points for the coefficient of friction of well-lubricated cable is a drop down option in the app. If lubricant is not used, triple the values in the table.