RCircuitCalc vs Conduit Bending

This application is intend for engineers and students who are wasting time for designing electric and electronic circuits. The standard resistance values based on E-series numbers are outputted in inputting necessary conditions such as input voltage, output voltage, current and so on. Features The calculable circuits are as follows: - Voltage Dividers (Inputting output voltage or resistance ratio) - Series Circuits - Parallel Circuits - Combination Circuits In the Voltage Dividers, resistance values are calculated in entering input voltage, output voltage or resistance ratio, and current into input boxes, besides, the most suitable resistance values are calculated in selecting priority whether Normal or Vout. In the Series Circuits, Parallel Circuits and Combination Circuits, divided resistance values are calculated in entering a combined resistance value into an input box. Calculated resistance values are displayed with the following E-series number specified either. E6, E12, E24, E48, E96 This application is able to calculate current and power of each resistor on calculated resistance values. Attention Because standard resistors are used and precision of calculation is ensured, the following restrictions are set up. - Range of resistance value: 1Ω ~ 10MΩ - Range of resistance ratio: 0.1 ~ 10

Conduit Bending is a conduit bending calculator for electricians: 17 bend calculators for offsets, rolling offsets, 3-point and 4-point saddles, 90° bends and corners, with your bender's numbers built in. Pick your bender, enter the measurements, and get the marks for the bend. No bending chart, no working it out on the back of a box. Switch between imperial (inches) and metric (cm) at any time. OFFSET BENDS • Offset: Basic • Offset: 1st Bend Critical • Offset: 2nd Bend Critical • Offset: Parallel Adjustment for parallel runs ROLLING OFFSET CALCULATOR • Rolled Offset: Basic • Rolled Offset: 1st Bend Critical • Rolled Offset: 2nd Bend Critical SADDLE BENDS • 3-Point Saddle: Basic and Critical distance • 4-Point Saddle: Basic and Critical distance 90° BENDS • 90°: Basic • Back to Back 90° • Kicked 90° CORNERS • Corner around a square obstacle • Corner around a rectangular obstacle • Corner around a round obstacle BENDERS AND UNITS • Choose from more than 30 predefined hand, Chicago, electric and hydraulic benders • EMT, IMC, rigid (RMC) and PVC conduit, from 1/2" to 5" • Work in inches or centimeters • A built-in calculator that handles fractions and converts between cm and inches, from the makers of Calculator+ Whether you bend conduit every day or are learning how to bend conduit, Conduit Bending puts every bend in one pipe bending calculator on your iPhone. Conduit Bending is free to use with ads. A subscription removes the ads. Also from xNeat: Construction Calculator and Pipe Fitting. Terms of Use: https://www.apple.com/legal/internet-services/itunes/dev/stdeula/