PipeFit Pro: Pipe Calculator

NEW — a different fitting on each end of a spool Spool Cut now takes a 90 on one end and a 45 on the other. One pass, one cut length. Each end's take-out is listed separately, with the source of the number beside it. Thanks to the fitter who wrote in and asked for this. FIXED — accuracy • Switching between Imperial and Metric now converts what you entered. Before, your numbers were re-read under the new unit, so a measurement could change meaning when you flipped the toggle. • Deg ↔ mm/m reported the wrong slope in Metric. • The Rolling Offset diagram labelled the hypotenuse "Travel". That side is the True Offset — Travel lies in another plane. • Short Radius is offered only on sizes ASME B16.28 actually covers (NPS 1"–24"). Sizes outside the standard no longer show an SR take-out. • Take-out now always states where the number came from: a tabulated ASME value, or a calculated approximation for angles the standard does not tabulate. If you saved work in Metric before this update, it is worth checking it again. IMPROVED • Angle marks on the Miter Cut, Segment Elbow and Weld Prep drawings now show what they are measured from. • Bolt numbers on the flange pattern are readable on every pressure class. • The Saved list shows every calculator type, not just the offsets. • The About screen reports the real app version.