Wifi Rig CTRL

WifiRigCTRL is a controller app that lets you remotely operate an amateur (ham) radio transceiver from your iPhone or iPad over Wi-Fi. Two ways to connect: 1. Via Raspberry Pi (Hamlib/FastAPI) — CAT control for a wide range of rigs, plus RX audio, CW, FT8 and APRS 2. Direct CI-V — connect to an IC-705 / IC-9700 on the same Wi-Fi, no Raspberry Pi required for basic operation ■ Features - Real-time display of RX frequency, mode and signal strength (S-meter) - Change frequency, mode, TX power, squelch and filter width - Play received audio through the speaker (with noise reduction) - PTT ON/OFF and microphone audio transmission - Wi-Fi PTT (PTT control via external devices such as M5Atom) - CW decoding (multi-station, up to 5) and CW transmit (presets, WPM control) - BLE CW keyer support (connect DualKey-BLE / RemoteKeyer-BLE over Bluetooth) - FT8/FT4 decode and transmit - APRS beacon transmission (with smartphone GPS) - Multiple profiles (switch between connection targets) - API key authentication and remote access over WireGuard VPN ■ What you need (important) This app does not work on its own. You must have one of the following (your own hardware): - A set-up Raspberry Pi Zero 2W connected to your radio (Hamlib/FastAPI installed), or - An IC-705 / IC-9700 (for direct CI-V connection) Connect it to the same Wi-Fi network as your iPhone. Raspberry Pi setup instructions and firmware are published on GitHub: https://github.com/ji1ore/M5CoreHamCAT ■ Who it's for For licensed amateur radio operators who have a compatible radio setup. This app contains no ads and no usage tracking. Any information is used only on your device and is never sent to external servers.