Good Practices vs Bend Designer

Information contained in this app consists of data and calculators for plumbing and heating contractors engaged in the installation of gas-fired equipment only in the areas served by Enbridge Energy Utah/Wyoming/Idaho. Enbridge Energy Utah/Wyoming/Idaho provides retail gas-distribution service to customers in Utah, southwestern Wyoming and a small portion of southeastern Idaho. Information contained herein has been extracted from local codes adopted and incorporated by local authorities into heating or plumbing ordinances or codes and hence mandatory; however, the information does not attempt to set forth all requirements of any such ordinances or codes. Enbridge Energy Utah/Wyoming/Idaho recommends all plumbing and heating contractors become thoroughly familiar with the requirements of the applicable ordinances or codes, contained in the International Fuel Gas Code (IFGC), International Residential Code (IRC), International Mechanical Code (IMC), International Plumbing Code (IPC), National Electrical Code (NEC), American Gas Association (AGA) standards, National Board of Fire Underwriters (NBFU), National Fire Protection Association (NFPA), Enbridge Energy Utah/Wyoming/Idaho Policy & Procedures, as well as with the information contained herein so gas installations made by them will measure up to the proper standards of quality and workmanship. Enbridge Energy Utah/Wyoming/Idaho is not responsible for the safe or proper installation of gas piping, equipment or appliances beyond its meter and does not, by the publication and distribution of this information, assume any such responsibility. Although every effort is made to ensure the app data and calculators are accurate and updated on a timely basis, changes incorporated in may not be immediately reflected in this application.

Dynamically design tubes by adding bends and changing dimensions to create exactly what you need. Then use the apps output along with the Reftekk Digi-Bender to create the tube you designed. This app is designed to be used with the Reftekk Digi-Bender. Do not use it with any other bender. This app is designed to be used with H55 ACR Type-L bendable copper tubing. Do not use any other tubing.