REMAKE vs FeedbackGuard

Remake is a multi-band effect designed for rich and crisp sound. The input signal is split into 3 parts. Then resonances are added to the lows (under 100Hz) and at the same time two harmonic voices are added to the mid frequencies only. One unison voice and one on perfect fifth interval. These 2 voices have their own positions in the stereo. Then the original mids are mixed with the additional voices and the signal goes through warm and gentle overdrive/gain booster effect with gain control. The high frequencies of the sound are sent through slight vibrato effect. All these signals are finally mixed on the output to form the result sound. The effect can work as a stand alone app and as an audio unit AUV3 plug-in. Controls: - Bass Vibe - amount of resonances on the low frequencies - Mid Gain - gain on the midshipmen’s - Voices - level of the additional mid voices - Reverb This is my first multi-band effect and I made it on a music hack day at Vienna to demonstrate my audio technology.

FeedbackGuard is an Audio Unit v3 effect that stops acoustic feedback before it ruins your performance. Whether you are singing live, speaking on stage, or recording vocals on iPad, FeedbackGuard listens for runaway howling and automatically places precise notch filters — so you can focus on the show, not the squeal. HOW IT WORKS FeedbackGuard uses PNPR (Peak-to-Neighbourhood Power Ratio) analysis combined with a growth check to tell real feedback apart from normal voice, speech, or room tone. When a howling peak starts to build, the plugin tracks it with parabolic peak detection and deploys an adaptive notch bank that reacts in milliseconds. Designed for live use: attack and release times, suppression depth, and notch count are all under your control. KEY FEATURES • Real-time howling detection (PNPR + run-up check) • Adaptive notch bank — up to 24 simultaneous notches • Live spectrum display with active notch markers • "Balanced" preset for safe, transparent defaults • 3 user preset slots — tap to recall, hold to save • Fine-tuned controls: Sensitivity, Notch Threshold, Suppression, Q, Attack, Release • Optional harmonic tracking for stubborn feedback tones • Optional spectral noise reduction for quiet passages • Full bypass GET STARTED IN SECONDS 1. Open your AUv3 host (GarageBand, AUM, Cubasis, and more) 2. Insert FeedbackGuard as an audio effect on your vocal or monitor channel 3. Tap "Balanced" for recommended live settings 4. Raise Notch Threshold if notches appear on voice or room tone IDEAL FOR • Live vocals and speech • Rehearsals, worship, small PA setups • Mobile recording rigs on iPhone and iPad • Any situation where monitor feedback is a risk COMPATIBILITY • Audio Unit v3 (aufx) effect • iPhone and iPad • Works in any AUv3-compatible host • Mono or stereo, sample rates from 8 kHz to 192 kHz FeedbackGuard — Adaptive Feedback Suppressor by Norwin Palme.