Forethumb vs Wifi Rig CTRL

Forethumb enables you to input characters on your iOS device with morse code. You can type sentences blindfold, if you memorized morse code for forethumb. [Function] - Character input is possible by single key type or paddle type Morse input. - The sound is played when you input the morse code. - In the case of the single key type, swiping the key to the left will "delete" and swiping to the right will "enter space". - You can change the default gap length. [Functional Limitations] - The characters that you can enter are alphabets, numbers, some symbols, and Japanese. [Attention] - You have to do the additional procedure of Forethumb to use it (Settings -> General -> Keyboard). - Then, you also have to turn on the "Full Access" for Forethumb. * Please don’t worry; The developer does not collect your data at all. [Support] - Please do not hesitate to contact the developer for any defect reports or questions/requests. - The developer will consider any requests about additional function. - The developer may end support for older iOS without notice.

WifiRigCTRL is an iPhone / iPad app for remotely operating your amateur-radio transceiver via a Raspberry Pi or ICOM CI-V (Wi-Fi / Bluetooth). Features: - Real-time RX frequency, mode and S-meter display - Change frequency, mode, power, squelch and filter width - RX audio playback through the speaker (with noise reduction) - PTT on/off and microphone transmit - CW Morse send and receive-decode (BLE / USB-NCM keyers) - RTTY AFSK transmit/receive (on-device software modem or via the Raspberry Pi's minimodem, with spectrum display) - FT8 / FT4 receive-decode and transmit - Automatic FT8 all-decode log to ~/ALL.TXT (WSJT-X compatible) - Band Scope (CAT single-sweep / native ICOM CI-V scope, with POTA/SOTA spots overlaid) - APRS beacon transmit (GPS) - QSO log (ADIF export, POTA/SOTA references) - Operating-location (JCC/JGC, grid) registration and operating sessions - eQSL auto-upload, Smart Ham Log integration, PSKReporter spotting - Band memory, POTA/SOTA spot integration (SP2ALART) - Multiple profiles, API-key auth, WireGuard VPN - Direct Wi-Fi / Bluetooth CI-V to Icom IC-705 / IC-9700 - One-tap Raspberry Pi SSH setup ■ Requirements (Important) This app does not work on its own. You need one of the following, owned by you: A Raspberry Pi Zero 2W that is already set up (connected to your radio, with Hamlib/FastAPI installed), or An IC-705 or IC-9700 (for a direct CI-V connection) Connect either one to the same Wi-Fi network as your iPhone. Setup instructions and firmware for the Raspberry Pi are available on GitHub: https://github.com/ji1ore/M5CoreHamCAT ■ Intended Users This app is for licensed amateur radio operators who have a compatible radio setup. *This app contains no ads and no usage tracking. All data it collects is used only on your device and is never sent to an external server.