Wireless Audio AUv3 vs Ringotron

Music making and audio processing has been growing and changing on iOS. The first app connections were with Audiobus, and then Inter-App Audio became available. The current standard is AUv3. There are many legacy apps and audio hosts, however, that have not updated. Wireless Audio AUv3 gives you an easy way to send audio from one iOS device to another using a low-latency WiFi connection; you can also connect audio unit hosts together -- either on a single device, or between devices using WiFi. There are no cables and boxes to buy (and to lose, or forget to take with you). Install the Transmit AUv3 onto an audio track of one host, the Receive AUv3 on the input slot of the audio track of another host, tap `connect,' and audio will be sent from one place to another with surprisingly low latency. The receiver can adjust buffering to maximize audio quality while minimizing latency. While your best results will be with a fast WiFi router and little cross-traffic on the network, you can still get a good connection even in noisy environments. Most modern DAWs support latency compensation, with the Receiver AUv3 reports -- this allows you to get precise synchronization of your recordings.

Ringotron allows taming the strong transformational effects of traditional ring modulation, opening up a wider range of possibilities in sound design and audio FX. Its multi-band design enables fine control over which parts of the spectrum will be transformed by the effect. A special soft mode is available that borrows concepts from feedback modeling, which can be used to reduce intermodulation effects that are often a limiting factor in the more general applicability of ring modulators. In addition to the layers of control they provide, combination of these core features also allows the plugin to act as a stereo, multi-peak resonant filter that can also smoothly morph into a ring modulator. FEATURES: • 2 parallel ring modulator units (max. modulator frequency: 8 kHz) • Stereo separation can be added to band center, mod. frequency, mod. phase • Ultra-narrow bands can be used to create highly resonant sounds • 4 large ribbon controls for band center and modulator frequencies • Band center frequencies can be modulated by the built-in modulation system • Tempo syncing can be independently configured for each oscillator • Built-in soft limiter and clipper to protect against volume spikes IMPORTANT INFORMATION: The plugin comes with a zero-latency, non-brickwall soft limiter, and as such, its stopping power is limited. Make sure to always leave enough headroom or use an external brickwall limiter for total protection against powerful transients. Alternatively, a built-in soft clipper is also available. PLEASE NOTE: • AUv3-compatible host app is required • Suported sampling rates: 44.1, 48, 96 kHz