PolyBud Polyrhythmic Sequencer vs S

PolyBud is a multitrack polyrhythmic AUv3 MIDI sequencer. You can add multiple note or MIDI CC tracks to the each pattern. The note tracks has the note, velocity, gate, ratchet, probability and randomisation modes. You can set different step lengths to the each mode which would introduce polyrhythmic variations immediately. Another great feature is the each track can run in a different rate which is great for creating unique polyrhythmic sequences. Also, you can assign different MIDI channels to the each track so that you can control multiple synths within a single PolyBud pattern. The MIDI CC tracks is great for modulating the synth parameters. You can introduce polyrhythmic modulations by setting the different step lengths and different rates to your MIDI CC tracks. Also, you can set a ramp value for smoothing up the CC value changes per step. If you set the ramp value to 0% then you can have the classic sample and hold modulation. PolyBud is a MIDI app and it don't produce any sound of its own. You need to route PolyBud's MIDI out to your audio apps in order to run PolyBud. For the AUv3 plugin, you need an AUv3 host app such as AUM, Cubase, NanoStudio, ZenBeats, BeatMaker, apeMatrix etc.

The whole Roland S-1 panel on your iPhone or iPad, over USB-C. The S-1 hides half its brain behind the Shift key. This editor puts all of it in front of you: all 54 parameters, laid out like the SH-101 panel — the synth the S-1 rebuilds — so the signal chain reads at a glance. WHAT IT DOES • All 54 control changes, with faders where the SH-101 had them and knobs where it did not. • Follows the hardware: move a knob on the S-1 and the screen follows in real time. • 60 factory presets in six categories. Versions of the patch charts from the original SH-101 manual, the club sounds the 101 became known for, and a bank built by ear against the unit. • Four sequencers: step piano roll, three-layer euclidean, scale-based generative and arpeggio. • Motion recording: move any control while it plays and it gets automated step by step. • A randomizer that blows up the whole engine and still leaves something audible. • Your own sound library, with export and import. • Light and dark. Spanish, English and Portuguese. WORTH KNOWING You need a Roland S-1 connected over USB-C. The editor makes no sound of its own: it sends MIDI to the unit, and the unit is what you hear. The S-1 does not answer SysEx. There is no way to read a sound out of it or store one over MIDI, so the library lives in the app and WRITE is pressed on the unit. The app selects the target pattern and dumps the sound so all you do is confirm. The whole parameter map comes from the official v1.02 manual. PRIVACY Nothing is collected. No accounts, no network, no analytics. Your sounds stay on your device. Made by fantasmogenesis.