Electrician's Helper vs Conduit Bending

Electrician’s Helper will take the hassle out of looking up electrical codes and doing complex calculations for installations. With Electrician’s Helper you can... ● Calculate voltage, current and power in 3 phase delta and wye circuits. ● Find the ampacity of a conductor as per the NEC and CEC tables. ● Calculate the voltage drop in a line based on length, size, current and temperature. ● Find the total box fill by entering the size and number of conductors, straps and clamps. ● Find the maximum number of conductors allowed in a particular size raceway based on NEC and CEC rules. ● Determine what size raceway is needed for a bundle of conductors. ● Find the maximum bend radius of a conduit. ● Find the maximum capacitor kvar for a motor and the current reduction obtained. ● Find the motor current, heater current, breaker required, wire size, starter and conduit size for a particular 3 phase motor. ● Find the full load current of an induction, squirrel cage, and synchronous motor. ● Find the locked rotor current of a single or 3 phase motor. ● Estimate the Maximum Pull Tension. ● Calculate voltage, current and kVA of single and three phase transformers. ● Do basic ohm’s law calculations. ● Find decimal equivalents of fractions. ● Convert temperature scales. ● Look up connector configurations. ● Look up NEC tables 315.60(C)(1-20) Tested with iOS 16.6 thru iOS 26.3 Please note that this is a calculator for codes used in the NEC and CEC. It is not a replacement for the code books.

Conduit Bending is a conduit bending calculator for electricians: 17 bend calculators for offsets, rolling offsets, 3-point and 4-point saddles, 90° bends and corners, with your bender's numbers built in. Pick your bender, enter the measurements, and get the marks for the bend. No bending chart, no working it out on the back of a box. Switch between imperial (inches) and metric (cm) at any time. OFFSET BENDS • Offset: Basic • Offset: 1st Bend Critical • Offset: 2nd Bend Critical • Offset: Parallel Adjustment for parallel runs ROLLING OFFSET CALCULATOR • Rolled Offset: Basic • Rolled Offset: 1st Bend Critical • Rolled Offset: 2nd Bend Critical SADDLE BENDS • 3-Point Saddle: Basic and Critical distance • 4-Point Saddle: Basic and Critical distance 90° BENDS • 90°: Basic • Back to Back 90° • Kicked 90° CORNERS • Corner around a square obstacle • Corner around a rectangular obstacle • Corner around a round obstacle BENDERS AND UNITS • Choose from more than 30 predefined hand, Chicago, electric and hydraulic benders • EMT, IMC, rigid (RMC) and PVC conduit, from 1/2" to 5" • Work in inches or centimeters • A built-in calculator that handles fractions and converts between cm and inches, from the makers of Calculator+ Whether you bend conduit every day or are learning how to bend conduit, Conduit Bending puts every bend in one pipe bending calculator on your iPhone. Conduit Bending is free to use with ads. A subscription removes the ads. Also from xNeat: Construction Calculator and Pipe Fitting. Terms of Use: https://www.apple.com/legal/internet-services/itunes/dev/stdeula/