Advancer AD20 vs Chainsaw Chain Finder

Advancer Smart OBD Dongle (AD20/AD20 Pro) is a smart diagnosis terminal that communicates with your iOS devices via BT 5.0. With the Advancer app, AD20 provides services like vehicle health check, diagnosis, driving habits analysis for car owners. Help the vehicle owner to check at any time whether the vehicle is out of order, display the cause of the fault and maintenance suggestions, monitor the status of the vehicle in real time and alert the safety hazards early to ensure your driving safety 1)OBD-II Diagnosis Advancer AD20 can read and categorize the fault codes (DTCs) that storage inside the vehicle ECU via standard OBD-II protocols. 2)In-depth Check In-depth check function allows you to do thorough check on vehicle systems like engine, powertrain, brakes, steering, safety, infotainment and so on, which helps owners to know the health condition of the car clearly and provide safe and comfortable driving experience on travels. Note: In-depth check on all systems is only supported on AD20 Pro; AD20 supports in-depth check on engine only. 3)Live Data When the car is started, Advancer will provide and demonstrate detailed vehicle status like battery voltage, engine revolution speed, coolant temperature, engine load, fuel trimming and so on. This will help you to get the real-time working conditions of the car. 4)Maintenance Light Reset Reset the maintenance counter and turn off the maintenance light after finishing maintenance. For your driving safety, make sure you have followed the manual when doing maintenance to your own car. Note: Maintenance light is a reminder set by car manufacturer, which reminds drivers to do maintenances when needed. When the reminder is on, the car will show info on the dashboard screen, or simply shows a light. 5)Trip Recorder When driving, Advancer will record the index like average speed, fuel consumption, mileage, max engine revolution speed, max coolant temperature and shows them on the app. This will help you to know vehicle status and fuel consumption info on the entire trip. 6)Driving Habits Monitor With the G-sensors inside Advancer, all the sharp turns, emergency brakes and sudden accelerations will be recorded and shown on the app after analyzed. This function will provide data support if you are willing to improve your driving skills.

Chain Finder works out what chain your saw takes from the chain itself — and then remembers it, so you only ever do it once. KEEP YOUR SAWS Add every saw you own and record its pitch, gauge and drive link count against it. Call them whatever you call them in the shed. Next time you are standing at a counter, you open the app and read your own note instead of trying to remember which one takes the 56 link and which takes the 72. MEASURE, AND WATCH IT NARROW Five possible pitches sit on the screen. Measure across three rivet centres, type the number, and the ones that cannot be yours grey out. One measurement usually takes it down to one or two — then a single tap files the answer against the saw it came off. WHEN TWO ARE TOO CLOSE, IT SAYS SO 3/8 inch and 3/8 low profile are four tenths of a millimetre apart across three rivets. No tape measure separates them and no honest chart pretends otherwise. Chain Finder tells you they are tied and gives you what actually breaks the tie. NO MODEL LISTS, NOTHING TO GO STALE There is no database of manufacturers here and no part numbers. It works from the chain in your hand, which is why it reads the same on a saw made this year and one made thirty years ago. Anything you type against a saw stays on your device. WORKS OFFLINE No account, no signal. Measure a clean chain, use a steel rule rather than a tape where you can, and check against the markings on your bar before buying.