Teradek Ranger vs LidarAC

Ranger Manager App Manage every parameter of you Ranger from the convenience of you smartphone. Pair units, update firmware, and configure all of Ranger's features (including spectrum analyzer, range finder, realtime RSSI indicator, etc.) remotely and save time in production. Pairing - Pair transmitters and receivers right from your device. Spectrum Analyzer - Ranger receivers include a built-in spectrum analyzer, allowing you to detect congestion in the area and determine which frequency offers the best performance for your devices. Channel Selection - Manually tune the channel that is best for your area in 5Mhz increments. Ranger can also be set remotely for 20 or 40Mhz bandwidth operation. Quality / Range Analyzer - See additional video quality and information about the distance between connected devices. Monitor individual RF channel RSSI values in realtime to feed back information to your operator or production partners to maximize your signal awareness. Output Format - Scale the output format directly from the Ranger Receiver as needed or set to Auto for maximum flexibility. Test Pattern - Output a test pattern directly from the Ranger Receiver. Quality Selection - Choose between Maximum Quality, Maximum Range, and Balanced. Broadcast Mode - Increase transmission range and prevent multiple receivers from interfering with each other when placed close together. Audio Settings - Enable a tone from the Ranger when camera recording is triggered or turn off completely. Display Settings - Control the OLED display of the Ranger system System Info - Check the current firmware version and apply updates when available. Perform factory reset of the transmitter and receiver directly from the Ranger Manager App

LidarAC – RX is the handheld control and monitoring interface for the LidarAC system, built to extend Tilta Nucleus M and N setups for modern focus workflows. The idea is simple: bring tools normally found on high-end hand units to the Nano by using an iPhone. The system consists of two Modes. RX acts as the handheld interface and connects to the Nucleus Nano II via Bluetooth. TX runs on a second iPhone mounted on the camera (iPhone 12 Pro or newer) and provides LiDAR-based distance data. RX already enhances the Nucleus on its own with custom lens profiles, focus scaling, and marker tools. The full potential unlocks when paired with TX, adding real-time distance data directly into the focus workflow. Instead of relying on raw motor values, the system translates focus into usable distance context. Depth of field is calculated and visualized in real time, helping focus pullers make faster and more confident decisions, especially in dynamic scenes. Lens profiles allow precise mapping between LiDAR data and lens behavior, including aperture-based depth of field. Camera profiles handle CoC and sensor offset, ensuring accurate results in real-world setups. The focus scale is fully interactive and can switch between a flat mode and a focus wheel inspired mode. Values can either be mapped visually like on the lens for intuitive pulling, or displayed linearly to better understand spatial relationships within the scene. Marker and tracking tools make it easy to set, follow, and recall focus points. Features like spot measurement, 2D and 3D tracking, and a top-down LiDAR view provide clear spatial awareness on set. Haptic feedback increases as you approach a marker, giving intuitive confirmation without looking away. Key features: • Real-time LiDAR distance data for people, faces, and eyes • Spot distance measurement • 2D and 3D tracking points • Top-down LiDAR scene view • Custom lens profiles with depth of field visualization • Multiple focus scale modes (linear, lens matched, logarithmic) • Marker-based focus assistance with haptic feedback